MACHINE CONNECTION WIRE
- 3 mt. length electric power supply earth wire (supplied).
MACHINE ACCESSORIES
- Use of accessories not supplied with machine can cause the increase of electromagnetic output
and decrease of machine immunity to external electromagnetic sources.
7 MAINTENANCE INSTRUCTIONS
User or person in charge of machine maintenance can only carry out procedures as follows:
OUTER CLEANING
Clean the upper belt side using a water-soluble detergent. Do not use solvents. Before cleaning make
sure the plug is disconnected.
BELT
If machine is not utilized for a long time, loose the belt tension with screws on the rear part of the
machine (see point 3.11).
LUBRICATION
Control the wooden board below the belt is well lubricated. The machine has a self-lubricating
system that spray oil to the belt every time the treadmill is powered up (do not turn on it more
than 2 times per day). One time per year check oil into the spray can and, if it is necessary, substitute
it with a new one. Every 300 km (value modified from SetUp), at turning on, the machine will go
down four times spraying oil for special belt lubrication. Use only vaseline spray oil can.
OIL CAN SUBSTITUTION
To substitute the spray oil can, when OIL word appears, open the plastic engine cover and screw the
black cap showing oil tank image; put one hand under the treadmill and push up the can .
Use the can cap because it is already connected with lubrication pipe.
BELT TENSION
See point 3.11
MACHINE CONNECTION WIRE- 3 mt. length electric power supply earth wire (supplied).MACHINE ACCESSORIES- Use of accessories not supplied with machine can cause the increase of electromagnetic outputand decrease of machine immunity to external electromagnetic sources.7 MAINTENANCE INSTRUCTIONSUser or person in charge of machine maintenance can only carry out procedures as follows:OUTER CLEANINGClean the upper belt side using a water-soluble detergent. Do not use solvents. Before cleaning makesure the plug is disconnected.BELTIf machine is not utilized for a long time, loose the belt tension with screws on the rear part of themachine (see point 3.11).LUBRICATIONControl the wooden board below the belt is well lubricated. The machine has a self-lubricatingsystem that spray oil to the belt every time the treadmill is powered up (do not turn on it morethan 2 times per day). One time per year check oil into the spray can and, if it is necessary, substituteit with a new one. Every 300 km (value modified from SetUp), at turning on, the machine will godown four times spraying oil for special belt lubrication. Use only vaseline spray oil can.OIL CAN SUBSTITUTIONTo substitute the spray oil can, when OIL word appears, open the plastic engine cover and screw theblack cap showing oil tank image; put one hand under the treadmill and push up the can .Use the can cap because it is already connected with lubrication pipe.BELT TENSIONSee point 3.11
การแปล กรุณารอสักครู่..
