In this study, SCG liquefaction was examined by varying retention
times from 5 min to 30 min in a hot-compressed water medium
and the results are illustrated in Fig. 1. As the gas yields were
very low (less than 1% mass fraction) under these experimental
conditions, they were lumped with the water soluble product as
WPS þ gas yields. As shown in Fig. 1, at a constant temperature of
300 C and a water/feedstock mass ratio of 5:1, the crude bio-oil
yield reached the highest point of 31.63% at a retention time of
10 min, then started decreasing to 22.68% as the retention time was
increased to 30 min. The results indicated that 10 minwas sufficient
to break down biomass and achieve the highest yield of crude biooil.
When a longer retention time was applied, the crude bio-oil
would be decomposed into smaller and lighter products and
gases, as evidenced by a decrease in the average relative molecular
mass of crude bio-oil from 479 g mol1 to 433 g mol1 when the
retention time increased from 10 min to 30 min. This speculation
can be further supported by the observation that yields of WSP and
gases showed a continuously increasing trend from 44.91% to
52.62% when the retention time changed from 10 min to 30 min.
This indicated that most of the organic matters in the raw material
were converted into the crude bio-oil, WSP and GP within 10 min.
In terms of SR, the yield remained constant at about 24.03% from
5 min to 25 min, and only showed a slight increase at a longer
retention time (30 min). This might be caused by the repolymerization
of the crude bio-oil compounds into the solid residues,
resulting in the decrease yield of the crude bio-oil. Our
experimental results showed that a long retention time impacted
the yield of SR less significantly, however favored the formation of
WSP, leading to a lower yield of the crude bio-oil product. Similar
results were observed in the reported studies from other researchers
[49,55].
Under our experimental scope, the highest yield of crude bio-oil
of 31.63% was achieved with a reaction time of 10 min. Therefore,
the retention time of 10 min was used in the following work to
investigate the effects of the temperature, water/feedstock mass
ratio and initial pressure on the SCG liquefaction.
ในการศึกษานี้ , SCG , ตรวจสอบการคงอยู่ครั้ง จาก 5 นาทีถึง 30 นาทีในน้ำอุ่นปานกลาง บีบอัดและผลลัพธ์ที่แสดงในรูปที่ 1 เป็นก๊าซที่ผลิตได้ต่ำมาก ( น้อยกว่า 1 % สัดส่วนมวล ) ภายใต้เหล่านี้ทดลองเงื่อนไข , พวกเขาถูก lumped กับละลายน้ำได้ผลิตภัณฑ์เป็นWPS þแก๊สผลผลิต ดังแสดงในรูปที่ 1 ที่อุณหภูมิคงที่ของ300 C และมวลน้ำต่อสารตั้งต้น อัตราส่วน 5 : 1 , ดิบน้ำมันไบโอผลผลิตถึงจุดสูงสุดของงานบริหาร % ในการเก็บเวลา10 นาที ก็เริ่มลดลง 22.68 และการเก็บรักษา คือเพิ่มเป็น 30 นาที พบว่า 10 minwas เพียงพอเพื่อทำลายลงและผลผลิตให้ได้ผลผลิตสูงสุดของดิบ biooil .เมื่อเวลาการเก็บรักษาอีกต่อไป ใช้น้ำมันไบโอ ออยล์จะถูกย่อยสลายไป และผลิตภัณฑ์ที่มีขนาดเล็กและเบาแก๊ส ดังเห็นได้จากการลดลงในระดับเฉลี่ยสัมพัทธ์มวลของน้ำมันไบโอ น้ำมันจาก mol1 550 กรัม mol1 433 กรัมเมื่อเวลาการเก็บรักษาเพิ่มขึ้นจาก 10 นาทีถึง 30 นาที การเก็งกำไรสามารถเพิ่มเติม ได้รับการสนับสนุน โดยการสังเกตว่า ผลผลิตของ WSP และก๊าซมีแนวโน้มเพิ่มขึ้นจากร้อยละ 44.91 อย่างต่อเนื่อง52.62 เมื่อการเวลาเปลี่ยนไปจาก 10 นาทีถึง 30 นาทีนี้แสดงให้เห็นว่าส่วนใหญ่ของสารอินทรีย์ในวัตถุดิบเป็นแปลงดิบ ไบโอ ออยล์ WSP GP ภายใน 10 นาที และในแง่ของ SR , อัตราผลตอบแทนคงที่ที่ประมาณ 24.03 % จาก5 นาทีถึง 25 นาทีและเพียงแสดงให้เห็นเพิ่มขึ้นเล็กน้อยที่ยาวเวลาเก็บกัก ( 30 นาที ) นี้อาจจะเกิดจาก repolymerizationของสารประกอบในน้ำมันสกัดชีวภาพกากของแข็งผลในการลดผลผลิตน้ำมันไบโอ น้ํามัน ของเราผลการทดลองแสดงให้เห็นว่า ในเวลาที่ได้รับผลกระทบยาวนานผลผลิตของ SR น้อยลงอย่างมาก อย่างไรก็ตาม การก่อตัวของโปรดWSP ไปสู่ผลผลิตลดลงของน้ำมันไบโอ ออยล์ ผลิตภัณฑ์ คล้ายผลที่พบในรายงานการศึกษาจากนักวิจัยอื่น ๆ[ 49,55 ]ภายใต้ขอบเขตการทดลองของเรา ผลผลิตน้ำมันดิบน้ำมันไบโอของงานบริหาร % สําเร็จ ด้วยปฏิกิริยาเวลา 10 นาที ดังนั้นในเวลา 10 นาที ใช้ในงานดังต่อไปนี้ศึกษาผลของอุณหภูมิของน้ำต่อสารตั้งต้น มวลและอัตราส่วนของความดันเริ่มต้น เอสซีจี , .
การแปล กรุณารอสักครู่..
