and then,
as a final step,
the bundles were subjected to 1 h bleaching (as described below). The average intensity of the UV radiation at a distance of 12 cm vertically below the UV lamp was estimated, by a chemical method based on photolysis of oxalic acid in the presence of uranyl ions, to be 1020 photons s1 m2.
2.4. Bleaching treatment/UV irradiation
A hydrogen peroxide solution (6% (g/v)) adjusted to pH 10 (measured by using a digital pH meter, Omega make), by adding ammonia water, was used for the bleaching treatment. No acceler- ators or stabilizers were used in this treatment. Instead, the bleaching solution was freshly replaced after every 20 min. Bleach- ing was carried out by immersing a bundle in the bleaching solu- tion at a ratio of hair to solution 1:75. After a known interval of time (a total of 1, 3, and 5 h) the bundle was washed with plenty of distilled water and air-dried. The 5 h bleached hair was then subjected to UV irradiation for a total time of 50–500 h.
2.5. Positron lifetime measurements
The PALS set up used was a standard fast–fast coincidence cir- cuit with BaF2 scintillators, coupled to photomultiplier tubes of type XP2020/Q having quartz window. The spectrometer had a time resolution of 220 ps. The experimental and procedural details of this technique may be found in Refs. [10,17].Thesource-sample sandwich geometry was used for positron lifetime measurements. One hair bundle was placed on either side of the positron source and the combination was held together tightly by a pair of clampa- ble aluminum plates that had circular holes at the center in line with the source spot (about 2 mm in diameter, deposited at the center of a 1.5 cm2 Kapton foil of 0.0127 mm thick). The thickness of the hair sample in the sandwich was about 2.5 mm, such as to ensure stopping of all the positrons inside the sample. A typical spectrum accumulation time was 2 h with a 17 lCi 22Na positron source, with more than 106 counts under each spectrum. The instrumental time resolution and source correction terms were ob- tained from the lifetime spectrum of a well-annealed (defects free) aluminum by using the program RESOLUTION [38].Thelifetime spectra in hair samples so acquired were analyzed into three
M.N. Chandrashekara, C. Ranganathaiah/Journal of Photochemistry and Photobiology B: Biology 101 (2010) 28
จาก นั้น,
เป็นขั้นตอน final,
รวมข้อมูลถูกต้อง 1 h ฟอกสี (ตามที่อธิบายไว้ด้านล่าง) ความเข้มเฉลี่ยของรังสีในระยะทาง 12 ซม.แนวตั้งด้านล่างหลอดไฟ UV ได้ประมาณ โดยวิธีเคมีตาม photolysis ของกรดออกซาลิกในต่อหน้าของ uranyl ประจุ ต้อง 1020 photons s 1 m 2.
2.4 ฟอกสีวิธีการฉายรังสี รักษา/UV
โซลูชันไฮโดรเจนเปอร์ออกไซด์ (6% (g/v)) ปรับปรุงค่า pH 10 (วัด โดยใช้เครื่องวัดค่า pH โอเมก้าทำ), โดยการเพิ่มน้ำแอมโมเนีย ถูกใช้สำหรับการรักษาฟอกสี ไม่ acceler ators หรือ stabilizers ที่ใช้ในการรักษานี้ แทน โซลูชันฟอกสีได้สดใหม่แทนหลังจากทุก 20 นาที เทพมรณะกำลังถูกดำเนิน โดยแช่กลุ่มในการฟอกสี solu-สเตรชันที่อัตราส่วนของผมเพื่อแก้ปัญหา 1:75 หลังจากช่วงที่ทราบเวลา (รวม 1, 3 และ 5 h) แล้วล้าง ด้วยน้ำกลั่น และ air-dried 5 h ผมเซลได้แล้วภายใต้วิธีการฉายรังสี UV เป็นเวลารวมของ h. 50 – 500
2.5 โพซิตรอนวัดอายุการใช้งาน
PALS ที่ตั้งใช้ได้ cir-cuit มีมาตรฐานรวดเร็ว – เร็วบังเอิญ มี BaF2 scintillators ควบคู่กับหลอด photomultiplier ชนิด XP2020/Q มีควอตซ์หน้าต่าง สเปกโตรมิเตอร์ที่มีความละเอียดเวลาของ 220 ps ทดลอง และขั้นตอนรายละเอียดของเทคนิคนี้อาจพบใน Refs [10,17]เรขาคณิตแซนวิ Thesource อย่างถูกใช้สำหรับการประเมินอายุการใช้งานของโพซิตรอน ผมกลุ่มหนึ่งถูกวางบนด้านใดด้านหนึ่งของแหล่งโพซิตรอน และชุดจัดขึ้นกันแน่นคู่แผ่นอลูมิเนียม clampa ble ที่มีหลุมกลมที่ศูนย์กลางกับจุดต้นทาง (ประมาณ 2 มิลลิเมตรเส้นผ่านศูนย์กลาง ฝากของฟอยล์แบบ Kapton 1.5 cm2 0.0127 มม.หนา) ความหนาของตัวอย่างผมในแซนวิได้ประมาณ 2.5 มม. เช่นให้หยุดของ positrons ทั้งหมดภายในตัวอย่าง H 2 กับ 17 lCi 22Na โพซิตรอนแหล่งที่มา มีจำนวนมากกว่า 106 ภายใต้แต่ละคลื่นสเปกตรัมทั่วไปสะสมเวลาได้ เวลาบรรเลงความละเอียดและแหล่งที่มาการแก้ไขเงื่อนไข ob-tained จากอายุการใช้งานจำนวนมากห้อง annealed (ข้อบกพร่องฟรี) อลูมิเนียม โดยใช้โปรแกรมแก้ปัญหา [38]แรมสเป็คตรา Thelifetime ในตัวอย่างผมจึง มาถูกวิเคราะห์ใน three
M.N. Chandrashekara, Ranganathaiah/สมุด เคมีแสงและ b: Photobiology C. 101 ชีววิทยา (2010) 28
การแปล กรุณารอสักครู่..
and then,
as a final step,
the bundles were subjected to 1 h bleaching (as described below). The average intensity of the UV radiation at a distance of 12 cm vertically below the UV lamp was estimated, by a chemical method based on photolysis of oxalic acid in the presence of uranyl ions, to be 1020 photons s1 m2.
2.4. Bleaching treatment/UV irradiation
A hydrogen peroxide solution (6% (g/v)) adjusted to pH 10 (measured by using a digital pH meter, Omega make), by adding ammonia water, was used for the bleaching treatment. No acceler- ators or stabilizers were used in this treatment. Instead, the bleaching solution was freshly replaced after every 20 min. Bleach- ing was carried out by immersing a bundle in the bleaching solu- tion at a ratio of hair to solution 1:75. After a known interval of time (a total of 1, 3, and 5 h) the bundle was washed with plenty of distilled water and air-dried. The 5 h bleached hair was then subjected to UV irradiation for a total time of 50–500 h.
2.5. Positron lifetime measurements
The PALS set up used was a standard fast–fast coincidence cir- cuit with BaF2 scintillators, coupled to photomultiplier tubes of type XP2020/Q having quartz window. The spectrometer had a time resolution of 220 ps. The experimental and procedural details of this technique may be found in Refs. [10,17].Thesource-sample sandwich geometry was used for positron lifetime measurements. One hair bundle was placed on either side of the positron source and the combination was held together tightly by a pair of clampa- ble aluminum plates that had circular holes at the center in line with the source spot (about 2 mm in diameter, deposited at the center of a 1.5 cm2 Kapton foil of 0.0127 mm thick). The thickness of the hair sample in the sandwich was about 2.5 mm, such as to ensure stopping of all the positrons inside the sample. A typical spectrum accumulation time was 2 h with a 17 lCi 22Na positron source, with more than 106 counts under each spectrum. The instrumental time resolution and source correction terms were ob- tained from the lifetime spectrum of a well-annealed (defects free) aluminum by using the program RESOLUTION [38].Thelifetime spectra in hair samples so acquired were analyzed into three
M.N. Chandrashekara, C. Ranganathaiah/Journal of Photochemistry and Photobiology B: Biology 101 (2010) 28
การแปล กรุณารอสักครู่..