Door Scratch !
Caused by careless opening door
BLACK HOLE DOOR GUARD
will be solution to protect your car !
blackhole Door Guard
Protect Door Ding
Protect Door Scratch
SUS support No Corrosion
Good Exterior
Reduce Wind Noise
Prevent to door dinging You will be mannered driver with Blackhole Door guard
Protect door scratch Even narrow car parking area Don’t worry about it !
SUS support pin does not make rust. Aslo It keep door gaurad tighten.
Corrosion TEST
SUS Pin + Water
SUS Pin + Salt Water
Iron Pin + Water
We have test for 6 week as a picture. You can’t not see any corrosion for SUS support Pin. But normal Iron pin has many corrosion.
Except for car door, You can mount it to Bonnet and Trunk door. It make your car to Unique design.
Installation
1. Pull out 1pcs of SUS pin.
2. Start to mounting door guard.
3. It is more easy and tighten mountinh by using rubber Hammer.
4. Check the end point of door guard and cut it.
5. Also pull out 1pcs of SUS pin.And finish installation.
6. Finish.
TIP !
Don’t you have rubber hammer ?
Don’ t worry about it. You can use just normal hammer which covered with towel. It is same performance as rubber Hammer.
Type and Composition
*It is only different shape. Performance is same as Typa A & B
Mounting door inside Position
Mounting door Outside
Type A
FOR USE Rear Door Trunk 3Door Automobile Coupe 2 Door Pick up car
Type B
FOR USE Front Door Bonnet Front Door of double cab Pick up
Option A Type A 5m + Type B 5m
Option B Type A 10m + Type B 10m
Option C Type B 5m
Option D Type A 5m
Option E Type B 10m
Option F Type A 10m
TIP !
If you mounting Type A this point, It is more effective to reduce wind noise. But, please take note. It should be mounted opposite side of Type A only this point.
Door Inside
Nomal Mounting
Only This Point
Door Outside