3. Materials and Method
Fifty groundwater samples were collected during premonsoon
and postmonsoon
seasons in
a grid pattern at five selected zones and five samples each at northern and southern part of the
river is collected at a distance of about 500 m, 1000 m, 1500 m, 2000 m and 2500 m from
River Noyyal in order to study the level of penetration of polluted water into the aquifer
system (Figure.1). Samples were collected during July 2008 (premonsoon)
; December 2008
(postmonsoon)
; July’ 2009 (premonsoon)
and December 2009 (postmonsoon).
Surface
water samples were collected using Aqua trap water sampler. For collection, preservation and
analysis of the samples, the standard methods (APHA, 1995) were followed. Electrical
conductivity and pH of water samples were measured in the field immediately after the
collection of the samples using portable pH and electrical conductivity meters. Na + and K + were measured by using a flame photometer. Total dissolved solids (TDS) were measured by
evaporation and calculation methods (Hem, 1991). Ca 2+ and Mg 2+ were determined
titrimetrically using standard EDTA. Chloride was estimated by AgNO3 titration. Sulphate
was analysed using the turbidimetric method (Clesceri et al. 1998). Nitrate was analysed
using UV–visible spectrophotometer (Rowell, 1994).
3 วัสดุและวิธีการ
เก็บรวบรวมห้าสิบตัวอย่างน้ำบาดาลในช่วง premonsoon
และ postmonsoon
ฤดูกาลใน
รูปแบบตารางที่โซนที่เลือกห้าและห้าตัวอย่างแต่ละที่ภาคเหนือและภาคใต้ของ
แม่น้ำจะเรียกเก็บที่ระยะทางประมาณ 500 เมตร, 1000 เมตร 1500 เมตร 2000 เมตรและ 2,500 เมตรจาก
แม่น้ำ Noyyal เพื่อศึกษาระดับของการรุกของน้ำปนเปื้อนลงไปในน้ำแข็ง
ระบบ (Figure.1) ได้เก็บตัวอย่างในช่วงกรกฎาคม 2008 (premonsoon)
; ธันวาคม 2008
(postmonsoon)
; กรกฎาคม 2009 (premonsoon)
และธันวาคม 2009 (postmonsoon)
พื้นผิว
เก็บตัวอย่างน้ำโดยใช้เครื่องเก็บตัวอย่างน้ำดักน้ำ สำหรับการเก็บรักษาและ
การวิเคราะห์ตัวอย่าง, วิธีการมาตรฐาน (APHA, 1995) ตามมา ไฟฟ้า
และการนำความเป็นกรดด่างของน้ำตัวอย่างถูกวัดในสนามทันทีหลังจาก
เก็บตัวอย่างโดยใช้ค่าพีเอชแบบพกพาและเมตรการนำไฟฟ้า นา + และ K + ถูกวัดโดยใช้โฟโตมิเตอร์ไฟ ของแข็งที่ละลายได้ทั้งหมด (TDS) ถูกวัดโดย
การระเหยและการคำนวณวิธี (หน้าหลัก, 1991) Ca 2 + และ Mg 2 + ถูกกำหนด
titrimetrically ใช้ EDTA มาตรฐาน คลอไรด์ที่ได้รับการประเมินโดย AgNO3 ไตเตรท ซัลเฟต
ได้รับการวิเคราะห์โดยใช้วิธีการ turbidimetric (Clesceri et al. 1998) ไนเตรตได้รับการวิเคราะห์
โดยใช้ UV-Visible Spectrophotometer (Rowell, 1994)
การแปล กรุณารอสักครู่..