Hard seed dormancy is a common problem with smooth loofah seed. Scarification, clipping and dry heat were used to break dormancy in smooth loofah seed at the Department of Horticulture, Kasetsart University, Bangkok, Thailand. A completely randomized design with 20 treatments was used involving: untreated seed (control), clipping, scarifying by scarifier at 40, 70 and 100 revolutions per minute (rpm) for 1 min, and dry heat at 60 C, 70 C and 80 C for 1e5 h. After breaking dormancy, seed germination was tested in four replicates, with 50 seeds per replicate. The thickness of the seed coat was measured under a digital microscope. The results showed that clipped seeds gave the highest germination (100%) and decreased mean germination time (3.58 d). Scarified seed using a scarifier at 70 and 100 rpm for 1 min resulted in germination rates of 67.0e75.5%, which was higher than for seeds scarified at 40 rpm.
The dry heat-treated seeds at 60 C for 3e5 h and at 70 C for 2e5 h had germination of 71.0e80.5%. The outer layer of seed coat scarified at 100 rpm for 1 min was thinner than those of un-scarified seed samples. Dry heat had no effect on the seed coat thickness, but affected cells of the inner seed coat as the sclerenchymous cells showed disordered characteristics and were non-uniform and seemed to have been torn off. Dry heat treatment and scarification significantly improved germination compared to the control treatment. However, 80% germination may not be considered as an effective method at a commercial scale where 100% germination is needed. Further investigation of more accessions that may have different seed coat thicknesses may be needed.
Copyright © 2016, Kasetsart University. Production and hosting by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).
ระยะพักตัวของเมล็ดยาก เป็นปัญหาที่พบบ่อยกับเมล็ดบวบเรียบ บันไดจึงประจุบวก , การตัดและความร้อนแห้งถูกใช้เพื่อทำลายการพักตัวของเมล็ดบวบเรียบในที่ภาควิชาพืชสวน มหาวิทยาลัยเกษตรศาสตร์ , กรุงเทพ , ประเทศไทย CRD 20 ทรีตเมนต์ที่เกี่ยวข้องกับ : เมล็ดดิบ ( การควบคุม ) , ตัด , scarifying โดยบันไดจึงเอ้อที่ 40 , 70 และ 100 รอบต่อนาที ( RPM ) เป็นเวลา 1 นาที และแห้ง ความร้อนที่ 60 C , 70 องศาเซลเซียสและ 80 องศาเซลเซียสนาน 1e5 . หลังจากการทำลายการพักตัวของเมล็ด การงอกของเมล็ดถูกทดสอบใน สี่ซ้ำกับ 50 เมล็ดต่อจําลอง ความหนาของเยื่อหุ้มเมล็ดที่เป็นวัดที่อยู่ภายใต้กล้องจุลทรรศน์ดิจิตอล ผลการศึกษาพบว่าเมล็ดที่ตัดให้ความงอกสูงสุด ( 100% ) และลดเวลาการงอกหมายถึง ( 3.58 D ) บันไดจึงเอ็ดเมล็ดโดยใช้บันไดจึงเอ้อ ที่ 70 และ 100 รอบต่อนาทีเป็นเวลา 1 นาที ส่งผลให้อัตราการงอก 67.0e75.5 เปอร์เซ็นต์ ซึ่งสูงกว่าเมล็ดบันไดจึงเอ็ดที่ 40 รอบต่อนาทีเมล็ดแห้ง ความร้อนที่ 60 C 3e5 H และที่ 70 องศาเซลเซียส สำหรับ 2e5 H มีการงอกของ 71.0e80.5 % ชั้นนอกสุดของเยื่อหุ้มเมล็ดของบันไดจึงเอ็ดที่ 100 รอบต่อนาทีเป็นเวลา 1 นาที บางกว่า และบันไดจึงเอ็ดเมล็ดตัวอย่าง ความร้อนแห้งไม่มีผลเยื่อหุ้มเมล็ดหนา แต่มีผลต่อเซลล์ของเมล็ดด้านในเสื้อเป็นเซลล์ sclerenchymous พบความหมาย ลักษณะ และความไม่สม่ำเสมอ และดูเหมือนถูกฉีกออก การใช้ความร้อนแห้งและบันไดจึง signi จึงปรับปรุงการงอกลดลงอย่างมีนัยสําคัญเมื่อเทียบกับกรรมวิธีควบคุม แต่ 80% งอกอาจไม่ถือว่าเป็นวิธีที่มีประสิทธิภาพในระดับเชิงพาณิชย์ที่ 100 % การงอกเป็นสิ่งจำเป็น การสอบสวนเพิ่มเติมอีก ตัวอย่างที่อาจแตกต่างกันเยื่อหุ้มเมล็ดหนา อาจจะต้องการสงวนลิขสิทธิ์สงวนลิขสิทธิ์ 2016 , มหาวิทยาลัยเกษตรศาสตร์ การผลิตและนำเสนอโดย บริษัท โฮสติ้งนี้เป็นการเปิดบทความภายใต้ใบอนุญาต CC by-nc-nd ( http : / / creativecommons . org / ใบอนุญาต / โดย NC / ND 4.0 / )
การแปล กรุณารอสักครู่..
