2.2. Chemicals
Petroleum ether, chloroform, ethyl alcohol, ethyl ether at analytical grade were purchase from Sigma.
2.3. Wax and oil content
The wax content was determined by the Folstar et al. (1976) method using a Butt extraction apparatus with chloroform as solvent under reflux for 30 min. The oil content was determined by the AOCS Am 2-93 method with petroleum ether reflux for 16 h in a Butt apparatus ( Aocs, 1998).
2.4. Oil composition
After oil transesterification according to the method proposed by Hartmann and Lago (1973), fatty acids composition was determined in a Varian gas chromatograph, model 3900, equipped with an automatic sampler, injector split ratio of 75:1; capillary column Chrompack CP-SIL 88 (100 mx 0.25 mm ID, 0.20 ìm film) with flame ionization detector (FID) and controlled by a computer running the STAR Chromatography Workstation software. Column temperature was programmed as follows: initial temperature of 120 °C/5 min, heating from 120 to 220 °C (3 °C min−1) and from 220 to 235 °C (1 °C min−1), hold at a temperature of 235 °C for 12 min. Nitrogen was used as carrier gas at a flow rate of 1 ml min−1 and hydrogen, at a flow rate of 30 ml min−1, was used as the make up gas. The injector temperature was set at 270 °C, while the detector was set at 300 °C. An injection volume of 1 μl was used for all samples and standards. Identification of fatty acids was performed by comparing the retention times of the samples with those of known fatty acids. In all, 37 patterns of saturated, monounsaturated and polyunsaturated fatty acids were determined (Supelco 37 Component FAME Mix – 47885-U). The relative amounts of the fatty acids were calculated from the total area of the peaks in the chromatograms and the results expressed in g 100 g−1 sample. Unsaponifiable matter was obtained by the AOCS Ca 6B-53 method (Aocs, 1998).
2.2. ChemicalsPetroleum ether, chloroform, ethyl alcohol, ethyl ether at analytical grade were purchase from Sigma.2.3. Wax and oil contentThe wax content was determined by the Folstar et al. (1976) method using a Butt extraction apparatus with chloroform as solvent under reflux for 30 min. The oil content was determined by the AOCS Am 2-93 method with petroleum ether reflux for 16 h in a Butt apparatus ( Aocs, 1998).2.4. Oil compositionAfter oil transesterification according to the method proposed by Hartmann and Lago (1973), fatty acids composition was determined in a Varian gas chromatograph, model 3900, equipped with an automatic sampler, injector split ratio of 75:1; capillary column Chrompack CP-SIL 88 (100 mx 0.25 mm ID, 0.20 ìm film) with flame ionization detector (FID) and controlled by a computer running the STAR Chromatography Workstation software. Column temperature was programmed as follows: initial temperature of 120 °C/5 min, heating from 120 to 220 °C (3 °C min−1) and from 220 to 235 °C (1 °C min−1), hold at a temperature of 235 °C for 12 min. Nitrogen was used as carrier gas at a flow rate of 1 ml min−1 and hydrogen, at a flow rate of 30 ml min−1, was used as the make up gas. The injector temperature was set at 270 °C, while the detector was set at 300 °C. An injection volume of 1 μl was used for all samples and standards. Identification of fatty acids was performed by comparing the retention times of the samples with those of known fatty acids. In all, 37 patterns of saturated, monounsaturated and polyunsaturated fatty acids were determined (Supelco 37 Component FAME Mix – 47885-U). The relative amounts of the fatty acids were calculated from the total area of the peaks in the chromatograms and the results expressed in g 100 g−1 sample. Unsaponifiable matter was obtained by the AOCS Ca 6B-53 method (Aocs, 1998).
การแปล กรุณารอสักครู่..
2.2 . เคมีภัณฑ์ปิโตรเลียมอีเทอร์คลอโรฟอร์ม , เอธิลแอลกอฮอล์ ethyl ether ที่วิเคราะห์เกรดซื้อจาก Sigma2.3 ขี้ผึ้งและปริมาณน้ำมันขี้ผึ้ง ) มีการกำหนดโดย folstar et al . ( 1976 ) วิธีการใช้เครื่องมือสกัดด้วยคลอโรฟอร์ม ก้นเป็นตัวทำละลายภายใต้การรีฟลักซ์เป็นเวลา 30 นาที เนื้อหาน้ำมันถูกกำหนดโดย aocs เป็น 2-93 วิธีย้อนปิโตรเลียมอีเทอร์ 16 H ในก้นเครื่อง ( aocs , 1998 )2.4 . องค์ประกอบของน้ำมันหลังจากการศึกษาปฏิกิริยาทรานส์เอสเทอริฟิเคชันตามวิธีการที่เสนอโดย Admin และ ลาโก้ ( 1973 ) , กรดไขมันถูกกำหนดในแก๊สโครมาโตกราฟเครื่องรุ่น 3900 พร้อมมีตัวอย่างอัตโนมัติโดยแยกหัวฉีดของ 75:1 ; หลอดเลือดฝอยคอลัมน์ chrompack cp-sil 88 ( 100 MX 0.25 mm ID , ì M ภาพยนตร์ 0.20 ) ด้วยเครื่องตรวจจับเปลวไฟ ( ไอออไนเซชัน FID ) และควบคุมโดยคอมพิวเตอร์ที่ใช้ดาวเครื่องเวิร์กสเตชันซอฟต์แวร์ อุณหภูมิของคอลัมน์จะถูกโปรแกรมดังนี้ อุณหภูมิเริ่มต้น 120 ° C / 5 นาที ความร้อนจาก 120 220 ° C ( 3 องศา C มิน− 1 ) และจาก 220 ไป 235 ° C ( 1 ° C มิน− 1 ) เก็บที่อุณหภูมิ 23 ° C เป็นเวลา 12 นาที ไนโตรเจนที่ถูกใช้เป็นพาหะ ก๊าซที่อัตราการไหล 1 − 1 มิลลิลิตรต่อนาที และไฮโดรเจน ในอัตรา 30 มิลลิลิตรต่อนาที− 1 เคยใช้เป็นสร้างก๊าซ หัวฉีด อุณหภูมิตั้งไว้ที่ 270 ° C , ในขณะที่เครื่องตรวจจับไว้ที่ 300 องศา ฉีดปริมาณ 1 μผมใช้ตัวอย่างมาตรฐาน การจำแนกชนิดของกรดไขมันที่กระทำโดยเปรียบเทียบเวลากักของตัวอย่างกับผู้ที่รู้จักกรดไขมัน ทั้งหมด 37 รูปอิ่มตัวไม่อิ่มตัวและกรดไขมันไม่อิ่มตัวที่เป็น ( supelco 37 ส่วนชื่อเสียงผสม– 47885-u ) ปริมาณสัมพัทธ์ของกรดไขมันที่ได้จากพื้นที่ทั้งหมดของยอดเขาในกลิ่นและผลที่แสดงในกรัมต่อ 100 กรัม− 1 ตัวอย่าง unsaponifiable ไม่ว่าจะได้มาโดยวิธี aocs CA 6b-53 ( aocs , 1998 )
การแปล กรุณารอสักครู่..