Additional information was tentatively extracted from fitting the experimental sorption data to the GAB model(Eq. (1)). In all cases sigmoid curves,typical of hydrophilic materials(Xiao etal.,
2012), were obtained. As seen in Table 1, the estimated GAB parameters (C, X0 and k) were very different depending on the agar as well as blend composition.Overall,the model seemed to adequately fit the experimental data as suggested by the high correlation coefficients (R2 > 0.99) and range of estimated k values (0< k < 1).
The Guggenheim constant, C, is related to the heat of sorption at the monolayer and can be used to quantify the strength of the established bonds between water molecules and the hydrophilic sites at the monolayer of the polymeric material(Xiao etal.,2012). For the pure polysaccharide films,this parameter followed the trend NA>AA>LBG;NA had clearly the highest C (∼20) followed by AA, whose C was half that of the estimated for NA,while the pure LBG showed the lowest value(∼6.4). This suggested that the interaction at the primary sorption sites was strongest for NA,the agar sample with higher sulfate content. Torres et al.(2012) found significantly higher C values for LBG(∼24–41 measured at 20–35 ◦C)when studying the water adsorption of gum powders at different temperatures. Interestingly,the greatest impact of LBG addition was seen for NA films;at 50% galactomannan content or higher,the role of LBG seemed to dominate the water sorption activity at the primary sorption sites resulting in a sharp decay of C. The estimated
C values for 50/50 and 25/75 NA/LBG, films with best mechanical properties, were lower than that of pure LBG(respectively, ∼4.1 and ∼3.3 against ∼6.4; Table 1).
Additional information was tentatively extracted from fitting the experimental sorption data to the GAB model(Eq. (1)). In all cases sigmoid curves,typical of hydrophilic materials(Xiao etal.,2012), were obtained. As seen in Table 1, the estimated GAB parameters (C, X0 and k) were very different depending on the agar as well as blend composition.Overall,the model seemed to adequately fit the experimental data as suggested by the high correlation coefficients (R2 > 0.99) and range of estimated k values (0< k < 1).The Guggenheim constant, C, is related to the heat of sorption at the monolayer and can be used to quantify the strength of the established bonds between water molecules and the hydrophilic sites at the monolayer of the polymeric material(Xiao etal.,2012). For the pure polysaccharide films,this parameter followed the trend NA>AA>LBG;NA had clearly the highest C (∼20) followed by AA, whose C was half that of the estimated for NA,while the pure LBG showed the lowest value(∼6.4). This suggested that the interaction at the primary sorption sites was strongest for NA,the agar sample with higher sulfate content. Torres et al.(2012) found significantly higher C values for LBG(∼24–41 measured at 20–35 ◦C)when studying the water adsorption of gum powders at different temperatures. Interestingly,the greatest impact of LBG addition was seen for NA films;at 50% galactomannan content or higher,the role of LBG seemed to dominate the water sorption activity at the primary sorption sites resulting in a sharp decay of C. The estimatedC values for 50/50 and 25/75 NA/LBG, films with best mechanical properties, were lower than that of pure LBG(respectively, ∼4.1 and ∼3.3 against ∼6.4; Table 1).
การแปล กรุณารอสักครู่..

ข้อมูลเพิ่มเติมที่ถูกสกัดไม่แน่นอนจากการปรับข้อมูลการดูดซับการทดลองกับรูปแบบ GAB (สม. (1)) ในทุกกรณีโค้ง sigmoid แบบฉบับของวัสดุที่ชอบน้ำ (Xiao etal.,
2012) ที่ได้รับ เท่าที่เห็นในตารางที่ 1 พารามิเตอร์ GAB ประมาณ (C, X 0 และ k) ที่แตกต่างกันมากขึ้นอยู่กับอาหารเลี้ยงเชื้อเช่นเดียวกับการผสมผสาน composition.Overall รุ่นดูเหมือนจะเพียงพอเหมาะสมกับข้อมูลการทดลองตามที่แนะนำโดยค่าสัมประสิทธิ์สหสัมพันธ์สูง (R2 > 0.99) และช่วงของค่าประมาณ k (0 <k <1).
คง Guggenheim, C, มีความเกี่ยวข้องกับความร้อนของการดูดซับที่ monolayer และสามารถใช้ในการวัดปริมาณความแข็งแรงของพันธะระหว่างโมเลกุลของน้ำและที่ เว็บไซต์ที่ชอบน้ำ monolayer ของวัสดุพอลิเมอ (ที่เสี่ยว etal. 2012) สำหรับภาพยนตร์ polysaccharide บริสุทธิ์พารามิเตอร์นี้ตามแนวโน้ม NA> AA> LBG; NA ได้อย่างชัดเจนมากที่สุด C (~20) ตามด้วยเอเอซึ่งมี C เป็นครึ่งหนึ่งของประมาณ NA ในขณะที่ LBG บริสุทธิ์แสดงให้เห็นว่าค่าที่ต่ำที่สุด (~6.4) นี้ชี้ให้เห็นว่าการทำงานร่วมกันที่เว็บไซต์หลักของการดูดซับเป็นที่แข็งแกร่งสำหรับ NA, ตัวอย่างอาหารเลี้ยงเชื้อที่มีเนื้อหาซัลเฟตสูง ตอร์เร et al. (2012) พบว่าสูงขึ้นอย่างมีนัยสำคัญค่า C เป็นเวลา LBG (~24-41 วัดที่ 20-35 ◦C) เมื่อศึกษาการดูดซับน้ำจากผงเหงือกที่อุณหภูมิที่แตกต่างกัน ที่น่าสนใจผลกระทบที่ยิ่งใหญ่ที่สุดของการเติม LBG ถูกมองสำหรับภาพยนตร์ NA; 50% เนื้อหา galactomannan หรือสูงกว่าบทบาทของ LBG
ดูเหมือนจะครองกิจกรรมการดูดซับน้ำที่เว็บไซต์หลักของการดูดซับผลในการสลายคมชัดของซีประมาณค่าC สำหรับ 50/50 และ 25/75 NA / LBG, ภาพยนตร์ที่มีสมบัติเชิงกลที่ดีที่สุดมีค่าต่ำกว่าที่บริสุทธิ์ LBG (ตามลำดับ ~4.1 และ ~3.3 กับ ~6.4; ตารางที่ 1)
การแปล กรุณารอสักครู่..
