3. Results and discussion
3.1. Mechanical properties
The tensile strength of the TPS and TPS/luffa fiber composites
with different luffa fiber contents (5, 10, 15 and 20 wt.%), tested
after 12 days of stabilization at 55% RH are shown inFig. 1a. The
tensile strength of the TPS was about 0.6 MPa and this increased
with increasing luffa fiber content up to 1.24 MPa at 10 wt.% luffa
fiber. Further additions of luffa fiber to 15 wt.% and 20 wt.% results
a slight decrease of tensile strength due to the agglomerate of the
luffa fiber. However, they were still higher than the tensile
strength of the TPS. Prachayawarakorn et al.[11], also showed that
the maximum tensile strength was obtained with addition of
10 wt.% cotton fiber. Luffa fiber did improve the tensile strength
of the TPS due to the strength of interaction between the luffa fiber
and the TPS matrix. The results are in agreement with the SEM and
FTIR observations.
The elongation at break of the TPS was 36.77% and this value decreased as the luffa fiber composition was increased in the composites (Fig. 1b). This is due to the rigidity of the luffa fiber that
acts as a restraint on the flexibility of the starch molecular chain.
A similar behavior has been reported by other authors[9,12,24].
3. ผลลัพธ์ และสนทนา
3.1 คุณสมบัติทางกล
แรงของคอมโพสิตเส้นใย TPS และ TPS/ผิว
กับเนื้อหาเส้นใยในผิวแตกต่างกัน (wt.% 5, 10, 15 และ 20), ทดสอบ
หลังจาก 12 วันของเสถียรภาพที่ 55% RH แสดง inFig. 1a ใน
แรงของ TPS กำลังแรง 0.6 และเพิ่ม
กับเพิ่มใยบวบ ใยเนื้อหาแรง 1.24 ถึงที่ผิว wt.% 10
ใย เพิ่มเส้นใยผิว 15 wt.% และ 20 wt.% ผลลัพธ์เพิ่มเติม
ลดลงเล็กน้อยของแรงเนื่องจากการจับเป็นก้อนของ
ใยบวบใย อย่างไรก็ตาม พวกเขายังคงสูงกว่าแรงดึง
ความแข็งแรงของ TPS Prachayawarakorn et al. [11], นอกจากนี้ยังพบว่า
แรงสูงสุดได้รับบวก
ใยฝ้าย wt.% 10 ใยบวบใยไม่เพิ่มแข็งแรง
ของ TPS เนื่องจากความแรงของปฏิสัมพันธ์ระหว่างใยผิว
และเมทริกซ์ TPS ผลลัพธ์จะยังคงการ SEM และ
สังเกต FTIR
elongation ที่แบ่งของ TPS ถูก 36.77% และลดเป็นส่วนประกอบของเส้นใยผิวค่านี้เพิ่มขึ้นในคอมโพสิต (Fig. 1b) นี่คือเนื่องจากความแข็งแกร่งของเส้นใยผิวที่
ทำหน้าที่เป็นความยับยั้งชั่งใจในความคล่องตัวของแป้งโมเลกุลลูกโซ่
ลักษณะคล้ายกันมีการรายงาน โดยคน [9,12,24]
การแปล กรุณารอสักครู่..

3 . ผลและการอภิปราย
3.1 . สมบัติเชิงกล
แรงดึงของ TPS และ TPS / ใยไฟเบอร์คอมโพสิต
ที่มีใยบวบเส้นใย ( 5 , 10 , 15 และ 20 โดยน้ำหนัก ) , ทดสอบ
หลังจาก 12 วันของการรักษาเสถียรภาพที่ 55 % ความชื้นสัมพัทธ์แสดง infig . 1 .
แรงดึงของ TPS คือประมาณ 0.6 MPA และเพิ่มขึ้นด้วยการเพิ่มปริมาณใยไฟเบอร์
ถึง 1.24 MPa ที่ 10 % โดยน้ำหนัก
ใยไฟเบอร์ผลของใยไฟเบอร์ต่อไปเพิ่ม 15 % โดยน้ำหนัก และ 20 % โดยน้ำหนัก
ลดลงเล็กน้อยจากแรงดึงเนื่องจากการการรวมตัวเป็นกลุ่มก้อนของ
ใยไฟเบอร์ อย่างไรก็ตาม พวกเขายังสูงกว่าแรง
ของ TPS . อดิศักดิ์ นาถกรณกุล et al . [ 11 ]
, นอกจากนี้ยังพบว่าแรงดึงสูงสุดได้ด้วยการเพิ่ม
10 % โดยน้ำหนักเส้นใยฝ้าย . ใยไฟเบอร์ทำปรับปรุง
แรงดึงของ TPS เนื่องจากความแรงของการปฏิสัมพันธ์ระหว่างใยไฟเบอร์
และ TPS เมทริกซ์ ผลลัพธ์อยู่ในข้อตกลงกับ SEM และ
( ข้อสังเกต การยืดตัวที่จุดแตกหักของ TPS คือ 36.77 ล้านบาท และมูลค่าลดลงเป็นใยไฟเบอร์องค์ประกอบมีค่าคอม ( รูปที่ 1A ) นี้เป็นเพราะความแข็งแกร่งของใยไฟเบอร์ที่
ทำหน้าที่เป็นความยับยั้งชั่งใจในความยืดหยุ่นของแป้งโมเลกุลโซ่ .
พฤติกรรมที่คล้ายกันได้รับรายงานอื่น ๆ ผู้เขียน [ 9,12,24 ]
การแปล กรุณารอสักครู่..
