Suppressed ion chromatography with the use of a conductivity detector was developed for the determination
of sulphite ions in wine samples. When a mixed solution of sodium carbonate, sodium bicarbonate,
and acetone was used as the mobile phase, simultaneous determination of eight inorganic anions
(i.e., fluoride, chloride, nitrite, nitrate, sulphite, phosphate, sulphate, and thiosulphate) was completed
in approximately 25 min. Linearity, reproducibility, and detection limits were determined for the proposed
method. In the case of sulphite detection, a linear calibration curve with a good correlation coefficient
of 0.9992 was obtained from the peak height of sulphite with a relative standard deviation (n = 6)
1.48%. In addition, the detection limit of sulphite was 0.27 mg/L at a signal-to-noise ratio of 3. Further, the
developed method was applied for the determination of sulphite contained in several wine samples.
โคปราบปรามไอออนที่มีการใช้เครื่องตรวจจับการนำรับการพัฒนาสำหรับความมุ่งมั่น
ของไอออนซัลไฟต์ในตัวอย่างไวน์ เมื่อแก้ปัญหาการผสมของโซเดียมคาร์บอเนต, โซเดียมไบคาร์บอเนต
และอะซีโตนถูกใช้เป็นเฟสเคลื่อนที่กำหนดพร้อมกันของแปดแอนไอออนนินทรีย์
(เช่นฟลูออไรคลอไรด์, ไนไตรท์, ไนเตรต, ซัลไฟต์, ฟอสเฟตซัลเฟตและไซโอ) แล้วเสร็จ
ในเวลาประมาณ 25 นาที เส้นตรง, การทำสำเนาและข้อ จำกัด การตรวจสอบได้รับการพิจารณาสำหรับการเสนอ
วิธีการ ในกรณีของการตรวจสอบซัลไฟต์, เส้นโค้งการสอบเทียบเชิงเส้นที่มีค่าสัมประสิทธิ์สหสัมพันธ์ที่ดี
ของ 0.9992 ที่ได้รับจากความสูงสูงสุดของซัลไฟต์ที่มีค่าเบี่ยงเบนมาตรฐานสัมพัทธ์ (n = 6)
1.48% นอกจากนี้ยังมีขีด จำกัด ของการตรวจสอบของซัลไฟต์เป็น 0.27 มิลลิกรัม / ลิตรที่สัญญาณต่อเสียงรบกวนอัตราส่วน 3. นอกจากนี้
วิธีการพัฒนาที่ถูกนำมาใช้สำหรับการตัดสินใจของซัลไฟต์ที่มีอยู่ในตัวอย่างไวน์หลาย
การแปล กรุณารอสักครู่..

Suppressed ion chromatography with the use of a conductivity detector was developed for the determination
of sulphite ions in wine samples. When a mixed solution of sodium carbonate, sodium bicarbonate,
and acetone was used as the mobile phase, simultaneous determination of eight inorganic anions
(i.e., fluoride, chloride, nitrite, nitrate, sulphite, phosphate, sulphate, and thiosulphate) was completed
in approximately 25 min. Linearity, reproducibility, and detection limits were determined for the proposed
method. In the case of sulphite detection, a linear calibration curve with a good correlation coefficient
of 0.9992 was obtained from the peak height of sulphite with a relative standard deviation (n = 6)
1.48%. In addition, the detection limit of sulphite was 0.27 mg/L at a signal-to-noise ratio of 3. Further, the
developed method was applied for the determination of sulphite contained in several wine samples.
การแปล กรุณารอสักครู่..
