Please you see SIR report of 6600445 assembly to 6600133 as attached file.
In the report I add the photo that I check GAP between the glass and the frames (that you comment on SIR of frame 6606130) and the result it’s good (sheet2)
I also add some problem that we found while we assembly 2 issue as below.
1. Problem from the GAP between channel door and the glass
we found after we assembly channel door on the glass and then we look at the end of channel door we found the GAP between the glass and channel door around 2 mm and distance around 2 -3 cm.
Not sure it’s was cause by the glass or the glue too much in side or the force ? I add some photo for show you on sheet 3.
2. Problem from Drawing Packing
Distance that you need for glue the foam block (on the base) we can’t glue on this position because this area have a step from the lid of carton.
So, we move distance for glue foam block on the end of the lid. some photo for show you on sheet 4.
Please you review as attached file and if you don’t understand please let me know.
Note : for the plate that we should be change on the jig 4000-122 (assembly the lock bracket), at the moment we still waiting part from laser cut
So, this lot of the lock bracket we make it by old jig.