analyte solution; 10 ml of it suffices to precipitate
530 mg of Sn alone.
2.4.10. Note 10
If Mo or V or both are present, the mass of the
precipitate in the sintered glass crucible on drying
is the sum of these two or three chelates. Hence, a
correction for this co-precipitation should be
made and Eq. (1) is modified as follows:
Sn%
(m2m14.382ma7.390mb)0.1687
G
100 (2)
where ma is the mass of Mo co-precipitated, mg;
4.382 is its conversion factor to MoO2L2 (L
stands for the TDTC anion here), i.e. 420.453:
95.94; mb is the mass of V co-precipitated, mg;
7.390 is its conversion factor to VO(OH)L2, i.e.
376.463:50.942.
Once m1 and m2 are known, ma and mb can be
determined as follows. Dissolve the precipitate in
aqua regia, dilute to a definite volume and take
aliquots for determining Mo by photometry with
thiocyanate and V by oxidimetry or 2,2%-
iminodibenzoic acid method [8], respectively.
3. Results and discussion
3.1. Choice of the precipitant for Sn(IV)
Sn(IV) is the stable species in the aqueous
medium, ligands of O,O-or S,S-donor type can
react with it. Unfortunately, these reactions are
poorly selective. Ligands of the latter type would
be preferred, however, because reaction selectivity
can be achieved by making use of the fact that
they, like sulfide ion, do not precipitate Sn(IV) in
an alkaline medium; but do most of the other
precipitable species. Among them dithiocarbamates
would be the candidates. It should be noted
that those of the mono-substituted group tend to
decompose readily in acidic and alkaline media
[9], whereas the disubstituted group do so in the
acidic medium only. Hence, the latter group
would seem recommendable. The Sn(IV)-DDTC
chelate was reported to be a mixture as the result
analyte โซลูชัน 10 ml ของ suffices กับ precipitateมก. 530 Sn เพียงอย่างเดียว2.4.10 การบันทึก 10ถ้าหมอ หรือ V หรือทั้ง ปัจจุบัน มวลของการprecipitate ในครูซิเบิลแก้วเผาอบแห้งคือผลรวมของ chelates นี้สอง หรือสาม ดังนั้น การการแก้ไขสำหรับฝนร่วมนี้ควรทำ และ Eq. (1) ปรับเปลี่ยนเป็นดังนี้:Sn %(m2 m1 4.382ma 7.390 mb) 0.1687G100 (2)ที่มาคือ มวลของ Mo ร่วมตะกอน มก.4.382 เป็นตัวแปลงมันจะ MoO2L2 (Lถึง TDTC anion ที่นี่), เช่น 420.453:95.94 mb คือ มวลของ V ร่วมตะกอน มก.7.390 เป็นปัจจัยการแปลงการโว (OH) L2 เช่น376.463:50.942เมื่อ m1 และ m2 เป็นที่รู้จักกัน ม้าและ mb สามารถกำหนดดังนี้ ละลาย precipitate ในaqua regia, dilute การปริมาตรที่แน่นอน และใช้aliquots สำหรับกำหนด Mo โดย photometry ด้วยthiocyanate และ V oxidimetry หรือ 2,2% -iminodibenzoic วิธีกรด [8], ตามลำดับ3. ผลลัพธ์ และสนทนา3.1 การเลือก precipitant สำหรับ Sn(IV)Sn(IV) เป็นชนิดมีเสถียรภาพในการอควีปานกลาง ligands ของ O, O- หรือ S, S-บริจาคชนิดสามารถตอบสนองกับ อับ ปฏิกิริยาเหล่านี้มีใช้งาน Ligands ชนิดหลังจะถูกต้อง อย่างไรก็ตาม เนื่องจากปฏิกิริยาใวสามารถทำได้โดยใช้ข้อเท็จจริงที่พวกเขา เช่นซัลไฟด์ไอออนปนเปื้อน ไม่ precipitate Sn(IV) ในด่างเป็นกลาง แต่ที่ทำส่วนใหญ่อื่น ๆสายพันธ์ precipitable ในหมู่พวกเขา dithiocarbamatesจะเป็นผู้สมัคร ควรจดบันทึกของกลุ่มแทนขาวดำมักจะเปื่อยพร้อมสื่อกรด และด่าง[9], ในขณะที่กลุ่ม disubstituted ทำให้ในการเปรี้ยวปานกลางเท่านั้น ดังนั้น กลุ่มหลังจะดูเหมือนนำเกี่ยวกับภัตตาคาร Sn (IV) -DDTCchelate เป็นรายงานที่จะผสมกันเป็นผล
การแปล กรุณารอสักครู่..

analyte solution; 10 ml of it suffices to precipitate
530 mg of Sn alone.
2.4.10. Note 10
If Mo or V or both are present, the mass of the
precipitate in the sintered glass crucible on drying
is the sum of these two or three chelates. Hence, a
correction for this co-precipitation should be
made and Eq. (1) is modified as follows:
Sn%
(m2m14.382ma7.390mb)0.1687
G
100 (2)
where ma is the mass of Mo co-precipitated, mg;
4.382 is its conversion factor to MoO2L2 (L
stands for the TDTC anion here), i.e. 420.453:
95.94; mb is the mass of V co-precipitated, mg;
7.390 is its conversion factor to VO(OH)L2, i.e.
376.463:50.942.
Once m1 and m2 are known, ma and mb can be
determined as follows. Dissolve the precipitate in
aqua regia, dilute to a definite volume and take
aliquots for determining Mo by photometry with
thiocyanate and V by oxidimetry or 2,2%-
iminodibenzoic acid method [8], respectively.
3. Results and discussion
3.1. Choice of the precipitant for Sn(IV)
Sn(IV) is the stable species in the aqueous
medium, ligands of O,O-or S,S-donor type can
react with it. Unfortunately, these reactions are
poorly selective. Ligands of the latter type would
be preferred, however, because reaction selectivity
can be achieved by making use of the fact that
they, like sulfide ion, do not precipitate Sn(IV) in
an alkaline medium; but do most of the other
precipitable species. Among them dithiocarbamates
would be the candidates. It should be noted
that those of the mono-substituted group tend to
decompose readily in acidic and alkaline media
[9], whereas the disubstituted group do so in the
acidic medium only. Hence, the latter group
would seem recommendable. The Sn(IV)-DDTC
chelate was reported to be a mixture as the result
การแปล กรุณารอสักครู่..
