to the higher degree of cross linking that results from the formation of
quinones and free radicals which tend to promote the cross linking
[133]. However, the permeability of the ferulic acid incorporated film
at a concentration of 100 mg increased slightly in comparison to the
blend film containing 75 mg of ferulic acid, but was lower than that of
the control film indicating 75 mg of ferulic acid as the optimal concentration
of the cross-linking agent. Blend films with higher TS had lower
WVT rates probably owing to the better degree of organization of the
polysaccharide network up to the optimum concentration of ferulic
acid. They also studied oxygen transmission rates of chitosan/starch
films with different amount of ferulic acid. In general, polysaccharide
films are expected to be good oxygen barriers, due to their tightly
packed and ordered hydrogen-bonded network structure and lowsolubility.
The results showed that the oxygen transmission rate reduced
with the increase in the level of cross-linking agent. Kucuk and Caner
[134] have reported better stability and quality for sunflower oil
samples stored under packaging conditions free of air. High levels of oxygen
in food packages have been reported to cause the development of
off-flavors, off-odors and nutritional loss in food stuffs [135].
Since a main function of a food packaging is often to avoid or at least
to decreasemoisture transfer between the food and the surrounding atmosphere,
or between two components of a heterogeneous food product,
WVP should be as low as possible.
Shen et al. [52] showed that theWVP of sweet potato starch films decreased
significantly with the addition of over 10% chitosan. This was
also the case for tapioca-starch-based edible film examined by Chillo
et al. [47]. They explained the decreasing WVP transmission rate at
higher concentrations of chitosan as a result of reducing the available hydrophilic
group [31,47]. In addition the hydrogen bonding interaction
between chitosan and starch decreased the free sorption sites for
water, which is responsible for decreasing theWVP of the film [136].
WVP of chitosan films (CS) contain different concentrations of tea
tree essential oil (TTO) had been studied by Sanchez-Gonzalez et al.
[100]. The room temperature conditions used for measuring the WVP
(100/54.4) of the films were established to simulate the environmental
conditions when the films are applied as a coating for vegetables.WVP
values were in the range of those reported by other authors working
with films based on chitosan [29].
The WVP values showed a significant decrease in line with the increase
in TTO concentration, reaching a maximum WVP reduction of
about 40% with incorporation of 2% TTO in the film-forming dispersions.
This behavior is expected as an increase in the hydrophobic
compound fraction usually leads to an improvement in the water barrier
properties of films, as was previously reported for essential oils
addition in CS films [96].
Fig. 23. The change of antibacterial activities of starch/chitosan blend films with radiation
dose (80% starch, 20% chitosan) [155].
Fig. 24.
ระดับสูงของ ข้ามการเชื่อมโยง ที่เกิดจากการก่อตัวของquinones และอนุมูลอิสระซึ่งมีแนวโน้มที่จะส่งเสริมการเชื่อมโยงระหว่าง[133] . อย่างไรก็ตาม permeability ของกรด ferulic รวมฟิล์มที่ความเข้มข้น 100 มิลลิกรัมเพิ่มขึ้นเล็กน้อยเปรียบเทียบผสมผสานฟิล์มประกอบด้วย 75 มก.กรด ferulic แต่ต่ำกว่าที่ฟิล์มควบคุมแสดง 75 มก.กรด ferulic เป็นความเข้มข้นสูงสุดตัวแทน cross-linking ฟิล์มผสมกับ TS สูงได้ต่ำกว่าราคาพิเศษ WVT คง เพราะระดับองค์กรของดีเครือข่าย polysaccharide ถึงความเข้มข้นสูงสุดของ ferulicกรด พวกเขายังเรียนราคาส่งออกซิเจนของไคโตซาน/แป้งฟิล์ม มีจำนวนกรด ferulic ที่แตกต่างกัน ในทั่วไป polysaccharideภาพยนตร์คาดว่าจะเป็นออกซิเจนดีอุปสรรค ผลของพวกเขาอย่างใกล้ชิดรวบรวม และสั่งไฮโดรเจนถูกผูกมัดโครงสร้างเครือข่ายและ lowsolubilityผลพบว่า อัตราการส่งออกซิเจนลดลงมีการเพิ่มขึ้นในระดับของ cross-linking แทน คุกุคคุและ Caner[134] มีรายงานเสถียรภาพดีและคุณภาพน้ำมันดอกทานตะวันตัวอย่างที่เก็บไว้ภายใต้เงื่อนไขบรรจุอากาศฟรี ระดับสูงของออกซิเจนอาหาร แพ็คเกจที่มีการรายงานทำให้เกิดการพัฒนาปิดรสชาติ กลิ่นออก และสูญเสียคุณค่าทางโภชนาการในอาหาร stuffs [135]เนื่องจากฟังก์ชันหลักของบรรจุภัณฑ์อาหารที่มักจะหลีกเลี่ยง หรือน้อยการโอน decreasemoisture ระหว่างอาหารและสภาพแวดล้อมor between two components of a heterogeneous food product,WVP should be as low as possible.Shen et al. [52] showed that theWVP of sweet potato starch films decreasedsignificantly with the addition of over 10% chitosan. This wasalso the case for tapioca-starch-based edible film examined by Chilloet al. [47]. They explained the decreasing WVP transmission rate athigher concentrations of chitosan as a result of reducing the available hydrophilicgroup [31,47]. In addition the hydrogen bonding interactionbetween chitosan and starch decreased the free sorption sites forwater, which is responsible for decreasing theWVP of the film [136].WVP of chitosan films (CS) contain different concentrations of teatree essential oil (TTO) had been studied by Sanchez-Gonzalez et al.[100]. The room temperature conditions used for measuring the WVP(100/54.4) of the films were established to simulate the environmentalconditions when the films are applied as a coating for vegetables.WVPvalues were in the range of those reported by other authors workingwith films based on chitosan [29].The WVP values showed a significant decrease in line with the increasein TTO concentration, reaching a maximum WVP reduction ofabout 40% with incorporation of 2% TTO in the film-forming dispersions.This behavior is expected as an increase in the hydrophobiccompound fraction usually leads to an improvement in the water barrierproperties of films, as was previously reported for essential oilsaddition in CS films [96].Fig. 23. The change of antibacterial activities of starch/chitosan blend films with radiationdose (80% starch, 20% chitosan) [155].Fig. 24.
การแปล กรุณารอสักครู่..
