Warning danger from prolonged or repeated contact with the oil and danger from splashes in the eyes. avoid prolonged or repeated contact with the skin. wear work uniform. glove and safety glasses.
2. Carefully open the oil filter bu turning the cap counter clockwise(see fig.4.39). hold a piece of rag underneath the filter to minimize oil spill. Take care not to lose the gasket and filter/strainer.
3. remove any dirt or foreign objects from the strainer(see fig.4.40). retain the strainer and cap unit oil has been replaced as described in the following steps.
4. remove the drain/filler cap and connect the oil pump using the hose adaptor.
5. drain the oil from the roll drive.
6. pump 6.5 liters of new oil into the roll drive using the same drain/filler connection as above.
If one of the covers for the roll drive has been removed for other inspections/repairs,it may be easier to pour the oil into the compartment through this opening rather than using the pump.
7. Disconnect the oil pump and refit and tighten the drain/filler cap.
8. Reinstall the oil filter and tighten the cap.
9. Clean up any oil spill.
10. Dispose the used oil in accordance with applicable regulations.
11. Perform task" PMA02: return antenna system to operational mode "(p.50)