EQUATIP DUAL TIP HOLDERS
The Equatip dual tip holder is a smaller version of the
Equa-Press holder (on next page). It is more compact, and
is more economical for those applications where it will
work equally well. An even smaller device, the Equatip
adapter (not water-cooled) is shown in box below.
Using the Equatip holder, both tips contact the work
squarely, because tip axes remain parallel to direction
of force (unlike the Teeter-Tip adapters). An internal
roller equalizes current and pressure between the two
electrodes, and will compensate for work height
variations up to 1/16”.
The holders are ordered with either 1” or 1-1/2”
spacing between barrels, and with tip sockets to accept
either male Tuffcap caps (5/8” dia.) or straight No. 4 RW
electrodes. (Bent tips are not recommended.) The distance
between welds can be varied by rotating offset-nose tips in
the barrels.
Equatip holders can be supplied with straight shanks
for arm mounting, a tapered adapter shank for holder
mounting, or a cylinder adapter shank to be clamped
to a cylinder rod.
Equatip holders can be used with forces up to 1000 lbs.