This deposit consists of talc, chlorite, actinolite, and a subordinate amount of calcite.
Based on semiquantitative results, the
Emirdağ samples were classified into 4 groups: i) talc- and
chlorite-bearing actinolite (E-1), ii) actinolite-rich talc (E-
2), iii) chlorite-bearing talc (E-3), and iv) pure talc (E-4).
While the highest amount of talc was observed in the pure
talc sample with 95 wt.%, talc mineral was determined as
10 wt.% in talc- and chlorite-bearing actinolite sample.
SEM studies revealed that fine-grain, plate, and sheet-like
microcrystalline talc crystals are associated with tabular,
acicular actinolite, and curved and flake-like chlorite.
In places, talc and chlorite are alteration products of
actinolites. During alteration of actinolite to talc, Fe and Ca decreased, but conversely Mg and Si increased. EDX
analysis of the Emirdağ talc samples was characterized
by high SiO2
(44.35–59.56 wt.%) and MgO (24.08–28.88
wt.%), but low Al2
O3
(0.49-3.29 wt.%). On the other
hand, high Ni (0.21–0.26 wt.%), and Cr (0.20–0.35 wt.%)
contents of the Emirdağ samples in chemical analyses are
conformable to the composition of talc deposits related to
ultramafic origin. Fe2
O3
content affecting the whiteness
of talc varies between 5.40 and 6.10 wt.%. The correlative
results obtained from EDX studies conducted on the talc
crystals and chemical analyses of the pure talc samples
indicated that iron takes place in the crystal lattice structure
of talc minerals. Accordingly, high IS (1.26 mm/s) and QS
(2.72 mm/s) values obtained from Mössbauer studies also
confirm the results of EDX and chemical analysis and
indicate that iron in the Emirdağ talc is thought to be Fe+2.
On the other hand, it was observed that the strong peak
intensities of the talc on the FT-IR spectra decrease with
reduction of the talc content in the samples, and different
endothermic/exothermic peaks and mass loss arose in the
DTA and TG curves consistently with the mineralogical
composition. According to the results of color analysis, the
WI and L values increase proportionally with talc content
but are inversely proportional to the iron and titanium
element contents of the talc samples. Taking into account
the physiochemical values, the talc from the Emirdağ
region does not have the qualities in its current form, such
as high purity, chemical content (particularly Fe2
O3
and
CaO), and other physical properties, especially whiteness,
that are required in industries like cosmetics, paint, or
paper. However, there might be a possibility of using it as a
secondary raw material in these industries.
เงินฝากนี้ประกอบด้วยแป้ง , คลอ Actinolite , ปริมาณ , และลูกน้องของแคลไซต์
ขึ้นอยู่กับผลลัพธ์ที่บริโภค ,
emirda ğตัวอย่างกลุ่มผม ) แป้ง -
คลอเรืองแอคทิโนไลท์ ( e-1 ) , 2 ) แอคทิโนไลท์ที่อุดมไปด้วยแป้ง ( E -
2 ) , 3 ) คลอแบริ่งแป้ง ( และ ) , และ 4 ) เพียว แป้ง ( e-4 ) .
ในขณะที่มีปริมาณแป้งสูงบริสุทธิ์อย่าง 95 น้ำหนัก
แป้ง% อย่างง่าย talc เขาเด็ด as
10 wt. % in talc ( bearing actinolite sample
sem tamponchika . studies revealed that grain , fine plate , ( sheet-like
microcrystalline talc crystals are associated with tabular ,
acicular actinolite , ( curved ส่งของด้วยอยาก
in ซัพ talc tamponchika . ( are alteration products เก็บกวาด tamponchika actinolites . ในช่วงการเปลี่ยนแปลงของแอคทิโนไลท์กับแป้ง เหล็กและแคลเซียมลดลงแต่ในทางกลับกัน mg และจังหวัดเพิ่มขึ้น การวิเคราะห์การวัด
ของ emirda ğแป้งตัวอย่างมีลักษณะโดย SiO2 สูง
( 44.35 – 59.56 % โดยน้ำหนัก ) และแมกนีเซียมออกไซด์ ( 24.08 – 28.88
% โดยน้ำหนัก ) แต่น้อย al2
O3
( 0.49-3.29 % โดยน้ำหนัก ) บนมืออื่น ๆ
, N สูง ( 0.21 - 0.26 % โดยน้ำหนัก ) และ Cr ( 0.20 ) 0.35 % โดยน้ำหนัก )
เนื้อหาของ emirda ğตัวอย่างในการวิเคราะห์เคมี
เหมือนองค์ประกอบของเงินฝากที่เกี่ยวข้องกับ
แป้งอัลตราเมฟิกที่มา fe2
O3
เนื้อหามีผลต่อความขาวของแป้งจะแตกต่างกันระหว่าง 600 และ 6.10 % โดยน้ำหนัก . ผลที่ได้จากการศึกษาการวัดคู่กัน
บนแป้งผลึกและวิเคราะห์ทางเคมีของตัวอย่างพบว่า เหล็กบริสุทธิ์โรยตัว
จะเกิดขึ้นในโครงผลึกโครงสร้าง
ของแป้งแร่ ดังนั้นสูง ( 1.26 มิลลิเมตร / วินาที ) และ QS
( 272 mm / s ) ค่าที่ได้จาก M ö ssbauer การศึกษา
ยืนยันผลของการวัด และการวิเคราะห์ทางเคมีและ
บ่งชี้ว่า ธาตุเหล็กใน emirda ğแป้งคิดว่าเป็นเหล็ก 2 .
บนมืออื่น ๆที่พบว่าแข็งแรงสูงสุด
เข้มของแป้งใน FT-IR สเปกตลดลง
การลดลงของปริมาณแป้งในตัวอย่างและแตกต่างกัน
ยอดการดูด / คายความร้อนและมวลการสูญเสียเกิดขึ้นใน
dta TG โค้งและสอดคล้องกับองค์ประกอบทางแร่
จากผลของการวิเคราะห์สี
วีและค่าเพิ่มตามปริมาณแป้ง
แต่จะแปรผกผันกับปริมาณธาตุเหล็กและไทเทเนียม
ของแป้งตัวอย่าง พิจารณาค่า
physiochemical , แป้งโรยตัวจาก emirda ğ
เขตที่ไม่มีคุณภาพในรูปแบบปัจจุบัน เช่น
ที่ความบริสุทธิ์สูง เนื้อหาเคมี ( โดยเฉพาะ fe2 O3
และโจโฉ ) และคุณสมบัติทางกายภาพอื่น ๆ โดยเฉพาะความขาว
ที่จําเป็นในอุตสาหกรรม เช่น เครื่องสําอาง , สี , หรือ
กระดาษ อย่างไรก็ตาม อาจมีความเป็นไปได้ที่จะใช้เป็นวัตถุดิบในอุตสาหกรรม
รองเหล่านี้
การแปล กรุณารอสักครู่..
