2.2. Switchgrass pretreatment by hydrothermolysis
Switchgrass was pretreated by hydrothermolysis in a 1 L Parr
pressure reactor (Parr Series 4520, Parr Instrument Company, Moline,
IL). Switchgrass was not extracted prior to pretreatment, only
prior to compositional analysis. The reactor was filled with 60 g of
dry switchgrass and 540 g of deionized water. The completely
sealed reactor was then heated to 200 C while being agitated at
150 rpm. The heating time took between 32 and 36 min. The temperature
was then held at 200 C for 10 min (Suryawati et al.,
2009). The reactor was immediately cooled in an ice bath until
the temperature fell below 30 C, which took approximately
10 min. The solid and liquid fractions were separated by vacuum
filtration through Whatman #5 filter paper. The solids were rinsed
and vacuum filtered with 2 L of deionized water to remove any
residual soluble sugars or compounds. A sample, approximately
6 g, of the washed residual solids was dried in an oven at 105 C
to determine the mass of dry solids recovered after pretreatment
(Sluiter et al., 2004c). The structural carbohydrate and lignin composition
of the pretreated switchgrass was then determined using
NREL LAP 002 (Sluiter et al., 2004b) as previously described. Thecarbohydrate content determined in this procedure was reported
as glucan and xylan instead of cellulose and hemi-cellulose because
the structural polysaccharides are hydrolyzed to monomer
sugars to be measured. Therefore, glucan and xylan represent the
total glucose and xylose content, respectively, in the material. This
pretreatment process was repeated multiple times, and the pretreated
solids were combined in order to accumulate enough
material to carry out the required experiments.
2.2 . สวิตซ์ปรับสภาพโดย hydrothermolysis
สวิตซ์เป็น hydrothermolysis กรัมใน 1 l .
ความดันถัง ( พาร์ชุดใน บริษัท , เครื่องมือพาร์โมลีน
, , ) สวิตซ์ไม่สกัดก่อนการบำบัดเพียง
ก่อนการวิเคราะห์ส่วนประกอบ . เครื่องปฏิกรณ์เต็มไปด้วย 60 กรัม
สวิตซ์แห้งและ 540 กรัม คล้ายเนื้อเยื่อประสานน้ำ สมบูรณ์
ปิดผนึกเครื่องปฏิกรณ์ถูกความร้อนแล้ว 200 C ในขณะที่กำลังปั่นป่วนที่
150 รอบต่อนาที เวลาเอาเครื่องระหว่าง 32 และ 36 นาที อุณหภูมิ
จัดขึ้นแล้วที่ 200 C นาน 10 นาที ( suryawati et al . ,
2009 ) เครื่องปฏิกรณ์ระบายความร้อนด้วยน้ำแข็งทันทีในอ่างจน
อุณหภูมิลดลงต่ำกว่า 30 C ซึ่งใช้เวลาประมาณ 10 นาที ส่วนที่เป็นของแข็งและของเหลว
โดยสูญญากาศแยกเศษส่วนการกรองผ่าน whatman # 5 ไส้กรองกระดาษ ของแข็งถูกล้างและการกรองสูญญากาศ 2
L
คล้ายเนื้อเยื่อประสานน้ำเพื่อลบใด ๆที่เหลือ ละลายน้ำตาล หรือสาร ตัวอย่างประมาณ
6 G , ล้างของแข็งที่เหลือก็แห้งในเตาอบที่ 105 C
หามวลของของแข็งแห้งหาย หลังการบำบัด
( sluiter et al . , 2004c ) ที่เป็นโครงสร้างและองค์ประกอบ
ลิกนินในการพิจารณาผ่านสวิตซ์แล้ว
nrel ตัก 002 ( sluiter et al . , 2004b ) ตามที่อธิบายไว้ก่อนหน้านี้ จะยับยั้งเนื้อหากำหนดในขั้นตอนนี้ถูกรายงาน
เป็นกลูแคนไซแลนแทนเซลลูโลสเซลลูโลส Hemi เพราะ
polysaccharides โครงสร้างย่อยเพื่อโมโนเมอร์
น้ำตาล เป็นวัด ดังนั้น ไซแลนแทน
กลูแคนรวมกลูโคสและไซโลส เนื้อหา ตามลำดับ ในวัสดุ การทำซ้ำกระบวนการนี้
หลายๆ ครั้ง และผ่านของแข็งถูกรวมในการสะสมวัสดุเพียงพอ
การดําเนินการทดลองต้อง
การแปล กรุณารอสักครู่..
