Tuesday morning, I started on the part of CBRD CPL 4 of all starting to prepare the equipment that will be made by a PIN and CPL CBRD PCB, then remove the PIN in the hole of the PCB until the solder pads then began as we put holes in the PCB PIN until all 4 are then soldered PCB pads that began as a hole that we put on hold until PIN 4 disconnected, then the check comes with CPL CBRD validator factory that each PIN can be inserted into the holes to fit or not. Check the fit with a factory inspector. All four finished checking enough I just started cleaning using solvent cleaners and cleaning the last step using a light meter measurements show that each PIN has to be shot. If the shot is not completed. I have studied English in the afternoon preliminary study manual from the Internet guys.
การแปล กรุณารอสักครู่..