According to previous studies [9,12], despite
the very long detention time (1 h), conditions applied
in Phase I (runs 1 and 2) resulted in an unsatisfactory
Mn removal, possibly due to the incomplete
oxidation of Mn at the natural pH. Furthermore,
half stoichiometric dose (1.74 mg/l) of
oxidizing agent (KMnO4) provided better removal
results than the stoichiometric one, possibly due
to the catalytic influence of MnO2 on the reactions
[16].
Based on the concentration of Mn in the previous
raw water samples (samples for runs 1 and
2), phase II experiments (runs 3–6) were conducted
using an oxidant dose equal to 1.74 mg/L
and 3.47 mg/L (0.5 and 1 stoichiometric doses
respectively) with the aim to evaluate the effects
of a higher pH value (pH 8.5). Results from these
runs (3–6) confirmed the appropriateness of using
a half stoichiometric dose of the oxidizing
agent and showed a better removal, as obtained
in previous studies [9,12]. However, a longer oxidation
time (30 min) was required. Despite the
positive effects of pH correction, concentrations
values below the MCL were achieved only by filtration
through the 0.45 μm filter, while the 35 μm
filter provided unsatisfactory performances.
ตามก่อนหน้านี้ศึกษา [9,12], แม้
ขังนานเวลา (1 h), เงื่อนไขใช้
ในเฟส ผม (ทำงาน 1 และ 2) เป็นผลในการใช้
เอา Mn อาจเป็น เพราะการไม่สมบูรณ์
ออกซิเดชันของ Mn ที่ pH ตามธรรมชาติ นอกจากนี้,
ครึ่ง stoichiometric ยา (1.74 mg/l) ของ
รับอิเล็กตรอนแทน (KMnO4) ให้เอาออกดีกว่า
ผลกว่า stoichiometric หนึ่ง อาจครบกำหนด
ให้ MnO2 อิทธิพลตัวเร่งปฏิกิริยาในปฏิกิริยาการ
[16]
ตามความเข้มข้นของ Mn ในก่อนหน้า
ตัวอย่างน้ำดิบ (ตัวอย่างสำหรับการทำงาน 1 และ
2), ได้ดำเนินการทดลองระยะ II (รัน 3–6)
ใช้ปริมาณอนุมูลอิสระเท่ากับ 1.74 mg/L
และ 3.47 mg/L (ปริมาณ stoichiometric 0.5 และ 1
ตามลำดับ) เพื่อประเมินผล
ของค่า pH สูงขึ้น (ค่า pH 8.5) ผลจากการนี้
รัน (3–6) ได้รับการยืนยันความใช้
stoichiometric ปริมาณครึ่งหนึ่งของรับอิเล็กตรอน
แทน และแสดงให้เห็นการเอาดีกว่า เป็นรับ
ในการศึกษาก่อนหน้านี้ [9,12] อย่างไรก็ตาม ออกซิเดชันยาว
(30 นาที) เวลาที่ถูกต้อง แม้มีการ
ผลบวกของค่า pH การแก้ไข ความเข้มข้น
สำเร็จค่าด้านล่าง MCL เท่านั้น โดยเครื่องกรอง
ผ่านตัวกรอง 0.45 μm ในขณะที่ 35 μm
กรองให้แสดงเฉย ๆ
การแปล กรุณารอสักครู่..
