The experimental plots did not significantly differ in their initial K forms (total, exchangeable, and soil
solution). The bulk density of peat soils depends on the amount of compaction, the botanical composition of
the materials, their degree of decomposition, and the mineral and moisture contents at the time of
sampling[16]. Bulk densities at the depths of 0–10, 10–25, and 25–45 cm were 0.16, 0.23 and 0.13 g cm–3,
and were typical of Umbro Saprists peat soil[16]. But the relatively high bulk densities at the depths of 0–10
and 10–25 cm may be due to cultivation and compaction, subsidence of peat soil, of the surface layers on
drainage[16]. The fact that the pineapple estate has been under use for about 36 years and has good drainage
systems supports this observation. The lower bulk density at the depth of 25–45 cm may be due to partial
decomposition of plant materials. Observation has shown that the bulk density in most tropical peat soils is
higher at the surface layers than the subsurface layers as the former surfaces tend be more sapric (full
decomposition) than the latter layers[16]. This has been associated with climate, height of water table, and
oxidation[16]. Perhaps materials at the depth of 25–45 cm may have been lignified.
The experimental plots did not significantly differ in their initial K forms (total, exchangeable, and soil
solution). The bulk density of peat soils depends on the amount of compaction, the botanical composition of
the materials, their degree of decomposition, and the mineral and moisture contents at the time of
sampling[16]. Bulk densities at the depths of 0–10, 10–25, and 25–45 cm were 0.16, 0.23 and 0.13 g cm–3,
and were typical of Umbro Saprists peat soil[16]. But the relatively high bulk densities at the depths of 0–10
and 10–25 cm may be due to cultivation and compaction, subsidence of peat soil, of the surface layers on
drainage[16]. The fact that the pineapple estate has been under use for about 36 years and has good drainage
systems supports this observation. The lower bulk density at the depth of 25–45 cm may be due to partial
decomposition of plant materials. Observation has shown that the bulk density in most tropical peat soils is
higher at the surface layers than the subsurface layers as the former surfaces tend be more sapric (full
decomposition) than the latter layers[16]. This has been associated with climate, height of water table, and
oxidation[16]. Perhaps materials at the depth of 25–45 cm may have been lignified.
การแปล กรุณารอสักครู่..

แปลงทดลองไม่แตกต่างกันอย่างมีนัยสำคัญในรูปแบบ K เริ่มต้นของพวกเขา (รวม, แลกเปลี่ยนและดิน
การแก้ปัญหา) ความหนาแน่นของดินพรุขึ้นอยู่กับปริมาณของการบดอัด, องค์ประกอบทางพฤกษศาสตร์ของ
วัสดุที่ระดับของการสลายตัวและแร่ธาตุและความชุ่มชื้นในขณะที่การ
เก็บตัวอย่าง [16] ความหนาแน่นเป็นกลุ่มที่ความลึก 0-10, 10-25 และ 25-45 เซนติเมตรเป็น 0.16, 0.23 และ 0.13 กรัมเซนติเมตร-3,
และเป็นเรื่องปกติของ Umbro Saprists พรุดิน [16] แต่ความหนาแน่นเป็นกลุ่มที่ค่อนข้างสูงที่ระดับความลึก 0-10
และ 10-25 เซนติเมตรอาจจะเกิดจากการเพาะปลูกและการบดอัด, ทรุดตัวของดินพีทของชั้นพื้นผิวใน
การระบายน้ำ [16] ความจริงที่ว่าอสังหาริมทรัพย์สับปะรดได้รับภายใต้การใช้งานประมาณ 36 ปีและมีการระบายน้ำดี
ระบบสนับสนุนการสังเกตนี้ ความหนาแน่นต่ำกว่าที่ระดับความลึก 25-45 ซม. อาจจะเป็นเพราะบางส่วน
สลายตัวของวัสดุพืช สังเกตได้แสดงให้เห็นว่ามีความหนาแน่นมากที่สุดในดินพรุเขตร้อน
ที่สูงขึ้นในชั้นผิวกว่าชั้นดินเป็นพื้นผิวที่มีแนวโน้มที่จะเป็นอดีต sapric เพิ่มเติม (เต็ม
สลายตัว) กว่าชั้นหลัง [16] นี้ได้รับการที่เกี่ยวข้องกับสภาพภูมิอากาศความสูงของน้ำและ
การเกิดออกซิเดชัน [16] บางทีอาจจะเป็นวัสดุที่ระดับความลึก 25-45 เซนติเมตรอาจได้รับ lignified
การแปล กรุณารอสักครู่..
