See plans for location and placement of item with reference to adjoining equipment.
Furnish and set in place per manufacturer’s standard specifications and the following:
1. Set in place in location as shown on drawings.
2. The dry weight capacity of the washer shall be 450 pounds.
3. Provide two speed extraction, single motor drive.
4. Provide bi-directional ribs for superior wash action.
5. Provide thee (3) water levels.
6. Provide float ire suspension system.
7. Provide “elite ll” advanced, integrated micro-controller which features:
a. Up to128 different wash formulas and 50 different chemicals.
b. 8 standard automatic supply signals.
c. Four line by 80 character vacuum fluorescent display.
d. 16 button keypad for data entry.
e. Washer control to be programmed from hand held programmer.
8. Door opening shall be on less than 1143 mm diameter, with a minimum cylinder volume of 2.242 cubic meters.
9. Provide with smooth flow water inlet valves , and anti-siphon breaker on water inlet.
10. Washer /extractor shall be provided with high pressure steam inlet valve. Lec to coordinate pressure with the steam generator plant.
11. Provide washer with liquid supply inlets. Lec shall be responsible for coordinating with the owner-selected detergent vendor on the final location and formulas.
12. Provide poly rinse water temperature (cool down), and gentle action for delicate textiles.
13. Provide rear drain.
14. Washer shall meet the following operating criteria: minimum 29 rpm wash speed; minimum 46 rpm balance speed; minimum 2869 rpm low extraction; 566 rpm high extraction
15. Washer shall be equipped with audio, visual warning signal during door opening and tilting.
16. Washer shall be mounted on air cushion (vibration mount) which are capable of removing 95% of the dynamic and static vibration generated by the washer /extractor.
17. Washer shall be equipped to centralized detergent dispensing system, detergent services will be contracted through the operator
18. Washer shall be forward tilt only. Lec must coordinate with the general contractor that the location of washer is clear of lights or conduits, etc.
19. Lec shall be fully responsible to the installation of the washer / extractor to the building infrastructure and laundry mechanical support equipment.
20. Must meet all applicable governmental, and local laws, rules, regulations, and codes.