sunflower husks, cotton husks, cotton stalk, coffee
husks, mustard stalk, palm fibre, soy husks, pepper
waste, groundnut shell and coconut shell (see Table 5
for composition) with silica sand as bed material. All
the materials, except palm fibre, resulted in bed agglomeration
within 4–6 h of operation. Experiments by Lin
et al. [39] have shown that the rate of agglomeration
increases at higher combustion temperatures (Fig. 7).
They monitored the process of agglomerate formation
at different temperatures in a laboratory scale fluidized
bed combustor (68 mm diameter, 1.14 m height) while
firing straw with 29% K2O in the ash by measuring
pressure drops in the bed. Each experiment was run
until the bed collapsed due to agglomeration. The
agglomeration time was found to decrease from around
2300 s to less than 500 s when the combustion temperature
was increased from 800 to 9508C.
Like wheat straw, some agricultural residues have low
contents of K2O and can be burnt in fluidized bed without
agglomeration problems. For example, Preto et al.
[34] reported successful burning of rice husks in a pilotscale
fluidized bed plant (cross-section 380 mm £
406 mm, total height 4.8 m) without experiencing any
agglomeration. The rice husks produced a very fine
ash, which was easily carried out from the bed and
was subsequently separated from the flue gas by
cyclone. It has been shown experimentally that rice
husks have a melting point much higher than the normal
operating temperatures of fluidized bed. For example,
Liu et al. [40] placed rice husk samples in crucibles
and heated for 2 h in an electric furnace at 950, 1000
and 10508C, respectively. The rice husk did not agglomerate
or slag. The ash fusion point of the rice husk was
found to be above 15008C [40]. In contrast, a marked
difference has been reported for rice stalks, which
normally have higher contents of alkali compounds
than the rice husks and exhibit low melting points [43].
ทานตะวัน " ฝ้าย " ฝ้าย , ก้าน , กาแฟ
" มัสตาร์ดก้าน เปลือกถั่วเหลือง กากปาล์ม กาก พริกไทย
, เปลือกถั่วลิสงและกะลามะพร้าว ( ดู ตารางที่ 5
ส่วนประกอบ ) กับทรายซิลิกาเป็นวัสดุที่เตียง ทั้งหมด
วัสดุ ยกเว้นปาล์มไฟเบอร์ ส่งผลให้เกิดการ
เตียงภายใน 4 – 6 ชั่วโมงของการดำเนินงาน การทดลองโดยหลิน
et al . [ 39 ] แสดงให้เห็นว่าอัตราการ
ช่วยเพิ่มการเผาไหม้ที่อุณหภูมิสูง ( รูปที่ 7 ) .
พวกเขาตรวจสอบกระบวนการซึ่งก่อตัว
อุณหภูมิในเตาเผาฟลูอิไดซ์เบดระดับห้องปฏิบัติการ
( 68 มม. เส้นผ่าศูนย์กลาง 1 เมตรสูง ) ในขณะที่
เผาฟางกับ k2o 29 % ในเถ้าโดยการวัด
ความดันลดลงในเตียง แต่ละการทดลองใช้
จนเตียงยุบเนื่องจากการ .
เวลารวม พบว่า ลดลงจากรอบ
2300 S น้อยกว่า 500 S เมื่อการเผาไหม้ที่อุณหภูมิเพิ่มขึ้นจาก 800 9508c
.
เหมือนฟางข้าวสาลี , การเกษตรตกค้างมีเนื้อหาน้อย
ของ k2o และสามารถเผาในฟลูอิดไดซ์เบดโดย
ปัญหาการ . ตัวอย่างเช่น จึง et al .
[ 34 ] รายงานการเผาไหม้ของแกลบ ประสบความสำเร็จใน pilotscale
ฟลูอิดไดซ์เบด เตียง ( ขนาด 380 มม. ผลิตพืช
406 มม. ความสูง 4.8 เมตร ) โดยปราศจากการใด ๆ
. ส่วน แกลบผลิตเถ้าดีมาก
ซึ่งสามารถนำออกมาจากเตียงและ
ต่อมาได้แยกออกจากก๊าซเผาไหม้โดย
พายุไซโคลน มันได้ถูกแสดงการทดลองว่าข้าว
husks มีจุดหลอมเหลวสูงกว่าปกติ
อุณหภูมิเบด .ตัวอย่างเช่น
Liu et al . [ 40 ] วางตัวอย่างแกลบในเบ้าหลอม
2 H และอุ่นในเตาอบไฟฟ้าที่ 950 , 1000
และ 10508c ตามลำดับ แกลบไม่จับเป็นก้อน
หรือตะกรันเหล็ก เถ้าหลอมจุดของแกลบ
พบเป็นข้างต้น 15008c [ 40 ] ในทางตรงกันข้าม , เครื่องหมาย
ความแตกต่างได้รับการรายงานในต้นข้าว ซึ่งปกติมีเนื้อหาที่สูงขึ้นของด่าง
สารกว่า แกลบ และมีจุดหลอมต่ำ [ 43 ]
การแปล กรุณารอสักครู่..
