quality of the ridge counts in the developed latent
print (on every type of surfaces) were not good (6.6)
(Table 1). Thus an improvement of this formula is
necessary. In contrast to the results presented here, it
has been shown that titanium dioxide, zinc oxide and
zinc carbonate can be used as effective particles in a
SPR suspension,(7) in contrast to the results of this
study. The differences in the quality of the ridge
counts might due to the particle size and oxide
concentration. To improve upon the SPR VI formula,
a reduction in the size of zinc carbonate particles, or a
suitable proportion of particle and detergent as well as
ratio of the two, or the use of a 10% (v/v) Aerosol OT
solution(8) or Kodak Photo Flo-200(9) as the detergent
should be considered. Since Photo Flo helps the
Small Particle Reagent to mix into solution or
suspension
quality of the ridge counts in the developed latent
print (on every type of surfaces) were not good (6.6)
(Table 1). Thus an improvement of this formula is
necessary. In contrast to the results presented here, it
has been shown that titanium dioxide, zinc oxide and
zinc carbonate can be used as effective particles in a
SPR suspension,(7) in contrast to the results of this
study. The differences in the quality of the ridge
counts might due to the particle size and oxide
concentration. To improve upon the SPR VI formula,
a reduction in the size of zinc carbonate particles, or a
suitable proportion of particle and detergent as well as
ratio of the two, or the use of a 10% (v/v) Aerosol OT
solution(8) or Kodak Photo Flo-200(9) as the detergent
should be considered. Since Photo Flo helps the
Small Particle Reagent to mix into solution or
suspension
การแปล กรุณารอสักครู่..
