end (,0 39.69 lifting rod to ram shank
then lift the rod up to check if the Ram
to the ram (with smaller clearance) a
will pull T-type ram slide back.
WARNING = _ .
The M16 socket
head screws.
hours then check if ribs overheat, the temp
temperature plus 25 °C.
' slow
%Ji
hole as drawing A
upward clearance
0.02mm. if need fine adjustment, take off or insert new
d' it ent the M20
to keep the correct clearance. And after a jus m ,
head screw tighten force about 3000kgf-cm.
mount dial gauge for side Way clearance checking by push or
pull the rod to left or right. If need any adjustment, loosen M16
cket head screw first, then turn M36 adjusting nut to drive the
so
adjusting screw; Clockwise turns will push T-type ram slide close
nd anti-clockwise turn adjusting
Please use‘ Torque Wrench for tighten force setting.
After the Ram got the correct clearance, dilly run machine for at le
erature should not over room
~,'
/
_j1'lJ_
nut will increase the clearance after lock the M16 socket head screw
head screw use 600 kgf-cm force to secure the M16 socket ;
ast 2
(8). If the sliders temperature acceptable and press not unmoral noise or
b th 'de before mounting die tooling
down, recheck the clearance o s1
QWARNING 1
While idle running, be alert for unusual sounds such as squealing,
scraping or grinding
smoothly and quietly. _
M — 9.81 N-M = 7.26lb-ft
Torque 100 Kgf-cm = 1.0 Kgf- -
All right reserved; Oct ‘O1
noises. Do not continue test if press does not cycle
end (,0 39.69 lifting rod to ram shankthen lift the rod up to check if the Ramto the ram (with smaller clearance) awill pull T-type ram slide back.WARNING = _ .The M16 sockethead screws.hours then check if ribs overheat, the temptemperature plus 25 °C.' slow%Jihole as drawing Aupward clearance0.02mm. if need fine adjustment, take off or insert newd' it ent the M20to keep the correct clearance. And after a jus m ,head screw tighten force about 3000kgf-cm.mount dial gauge for side Way clearance checking by push orpull the rod to left or right. If need any adjustment, loosen M16cket head screw first, then turn M36 adjusting nut to drive thesoadjusting screw; Clockwise turns will push T-type ram slide closend anti-clockwise turn adjustingPlease use‘ Torque Wrench for tighten force setting.After the Ram got the correct clearance, dilly run machine for at leerature should not over room~,'/\_j1'lJ_nut will increase the clearance after lock the M16 socket head screwhead screw use 600 kgf-cm force to secure the M16 socket ;ast 2(8). If the sliders temperature acceptable and press not unmoral noise orb th 'de before mounting die toolingdown, recheck the clearance o s1QWARNING 1While idle running, be alert for unusual sounds such as squealing,scraping or grindingsmoothly and quietly. _M — 9.81 N-M = 7.26lb-ftTorque 100 Kgf-cm = 1.0 Kgf- -All right reserved; Oct ‘O1noises. Do not continue test if press does not cycle
การแปล กรุณารอสักครู่..