Origin and characterization of textile wastewater
The ITE used in this work was the indigo jean dyeing wastewater.
It was provided by the treatment plant of SITEX located in
Ksar Hellal, Tunisia. The water demand of this factory was estimated
to be 2000 m3/d. The principal activities of this plant are
dying, warping, sizing, weaving and finishing. The ITE flow ratewas
measured to be around 1800 m3/d.
The determination of pH, total solids (TS), total suspended solids
(TSS), volatile solids (VS), electric conductivity (EC), BOD and COD
were performed according to standard methods (APHA, 1995). The
maximum absorbance of colorants was determined at
lmax ¼ 620 nm. The effluent was stored at 4 C for any following
uses. The Table 1 presents the physicalechemical characteristics of
the ITE with average values and for some similar researcher works
(Zylla et al., 2006; Khlifi et al., 2010). It shows that an effective
treatment of the ITE is required to reduce the level of pollution
parameters such as COD, OD620 and TSS.
Origin and characterization of textile wastewaterThe ITE used in this work was the indigo jean dyeing wastewater.It was provided by the treatment plant of SITEX located inKsar Hellal, Tunisia. The water demand of this factory was estimatedto be 2000 m3/d. The principal activities of this plant aredying, warping, sizing, weaving and finishing. The ITE flow ratewasmeasured to be around 1800 m3/d.The determination of pH, total solids (TS), total suspended solids(TSS), volatile solids (VS), electric conductivity (EC), BOD and CODwere performed according to standard methods (APHA, 1995). Themaximum absorbance of colorants was determined atlmax ¼ 620 nm. The effluent was stored at 4 C for any followinguses. The Table 1 presents the physicalechemical characteristics ofthe ITE with average values and for some similar researcher works(Zylla et al., 2006; Khlifi et al., 2010). It shows that an effectivetreatment of the ITE is required to reduce the level of pollutionparameters such as COD, OD620 and TSS.
การแปล กรุณารอสักครู่..

กำเนิดและลักษณะของน้ำเสียสิ่งทอ
ITE ที่ใช้ในงานนี้เป็นน้ำเสียครามย้อมสียีนส์.
มันถูกจัดให้โดยโรงบำบัดของ SITEX อยู่ใน
Ksar Hellal ตูนิเซีย ความต้องการน้ำของโรงงานแห่งนี้เป็นที่คาดกัน
ว่าจะเป็น 2000 M3 / D กิจกรรมหลักของพืชชนิดนี้จะ
ตายแปรปรวน, การปรับขนาด, การทอผ้าและการตกแต่ง ratewas ไหล ITE
วัดจะอยู่ที่ประมาณ 1,800 m3 / d.
การกำหนดค่า pH, ของแข็งทั้งหมด (TS) ของแข็งแขวนลอย
(TSS) ของแข็งระเหย (VS) การนำไฟฟ้า (EC), BOD และ COD
ได้ดำเนินการตาม วิธีการมาตรฐาน (APHA, 1995)
การดูดกลืนแสงสูงสุดของสีที่ถูกกำหนด
Lmax ¼ 620 นาโนเมตร น้ำทิ้งถูกเก็บไว้ที่ 4 องศาเซลเซียสสำหรับใดต่อไปนี้
การใช้งาน ตารางที่ 1 การจัดลักษณะของ physicalechemical
ITE ด้วยค่าเฉลี่ยและสำหรับบางงานวิจัยที่คล้ายกัน
(Zylla et al, 2006;.. Khlifi et al, 2010) มันแสดงให้เห็นว่ามีประสิทธิภาพ
การรักษา ITE จะต้องลดระดับของมลพิษ
พารามิเตอร์เช่น COD, OD620 และ TSS
การแปล กรุณารอสักครู่..

ต้นกำเนิดและลักษณะสมบัติของน้ำเสียสิ่งทอที่สนามที่ใช้ในงานนี้คือสีครามจีน อุตสาหกรรมฟอกย้อม .มันเป็นโดยการรักษาของพืช sitex ตั้งอยู่ในksar hellal , ตูนิเซีย . ความต้องการน้ำของโรงงานนี้คือประมาณเป็น 2 , 000 ลบ . ม. / วัน กิจกรรมหลักของพืชนี้ตาย , การปรับขนาด การทอผ้าและการตกแต่ง ที่เลี้ยงมันไหลวัดอยู่แถวๆ 1 , 800 ลบ . ม. / วันการหาค่า pH , ปริมาณของแข็งทั้งหมด ของแข็งแขวนลอยทั้งหมด ( TS )( TSS ) , ของแข็งระเหย ( VS ) ค่าการนำไฟฟ้า ( EC ) , บีโอดีและซีโอดีมีการปฏิบัติตามวิธีมาตรฐาน ( apha , 1995 ) ที่ค่าการดูดกลืนแสงสูงสุดของเม็ดสีถูกกำหนดที่¼ Lmax 620 นาโนเมตร น้ำที่ถูกเก็บไว้ที่ 4 องศาเซลเซียสเป็นเวลาใดต่อไปนี้ใช้ ตารางที่ 1 แสดงลักษณะของ physicalechemicalที่สนามด้วยค่าเฉลี่ย และบางคล้ายงานนักวิจัย( zylla et al . , 2006 ; khlifi et al . , 2010 ) มันแสดงให้เห็นถึงประสิทธิภาพการรักษาของ ITE จะต้องลดระดับของมลพิษพารามิเตอร์ เช่น COD , od620 และ TSS .
การแปล กรุณารอสักครู่..
