AMPLIFIERFUNCTIONS
1 Speaker connection Never connect the speaker cables with tho chassis ground This may destroy your Check that your speakers are connocted comecty which means plus to plus and minus to minus We recommend speaker cable from 2 25 mm to up. The connection ways are shown in the attachment.
2 BATT Battery terminal The.12 voit power cable must be connected with a fuse in line near the battery terminal Please see the table of cable and fuse selection.
3 REM Remote terminal The remote cable must be connected with the radio remote terminal so that the ampliler will switch on and off automatically with the radio. If there are two or more amplifiers installed together it might be necessary to add an additional relay. Please oonsult your dealer
4 GND Chassis ground terminal The chassis ground cable must be connected very tight on a nearby massive and electric conductive place.
5 Gain Gain control regulates the sensitivity of the amplifier lo match the signal output voltage of your source unit The gain control is not a volume adjustment Use high quality CD music and increase the volume of your source unit to 75% of its maximum volume, set the gain at the minimum and then increase gain slowly(clockwise) Stop at the first sign of distortion, then lower the gain a clockwise) to achieve clear undistorted music at the maxamum level
6 Remote Bass Level Control the bassievelcontrol you can adjust volume in the driver seat.
7 RCA audio input These RCA audio input connect your rado RCAoutputs Please use high quality RCA cables Keep th from your car e route RCA cables away from other current carrying cables in the car if rada has only speaker output, you must use a HIGH adaptor