The circuitry in the satellite that acts as the receiver, frequency changer, and transmitter is called a transponder. This basically consists of a low noise amplifier, a frequency changer consisting a mixer and local oscillator, and then a high power amplifier. The filter on the input is used to make sure that any out of band signals such as the transponder output are reduced to acceptable levels so that the amplifier is not overloaded. Similarly the output from the amplifiers is filtered to make sure that spurious signals are reduced to acceptable levels. Figures used in here are the same as those mentioned earlier, and are only given as an example. The signal is received and amplified to a suitable level. It is then applied to the mixer to change the frequency in the same way that occurs in a superheterodyne radio receiver. As a result the communications satellite receives in one band of frequencies and transmits in another.