Starting from the Initialize the hard ware.
Idle condition, wait for user commands through keys keys or mouse
Model Selection when users select the version of the meter to be calibrated. Program test will show the picture of the meter that class, and return to the state Idle.
When the user press work Load File program will load the specific data of test to the table and return to the state Idle.
when users press the button. Run. Program test will check letters printed in Serial number channel with the names of the calibration. That is to enter or not. Not identified to show warning. And go back to the Idle key again.
then verifies that the individual final test? If not the program to do the next step by sending the command to wavetek.
and Set lower & upper spec back to a condition Idle. But is the final return. State Idle.
When the key value read from the meter after calibration, and then press OK. The program tests to determine the type. Compared with the minimum and maximum limit.
If Accept Will Write Data to Table and Save Data from Table file are Report
If Reject will Wait confirm from user,and user press key the yes. Program will Write data to table. and Save that data from table to file report. If user Press "No" button will Clear that value Wait and wait key data again before return Idle stage.
The on / off signal simulation of Wavetek 9105.