THE SYSTEM OF EQUATIONS TO CALCULAT

THE SYSTEM OF EQUATIONS TO CALCULATE THE MASS FLOWS IS
DEPENDENT. THIS IS PROBABLY CAUSED BY TWO OR EVEN MORE
EQUATIONS FOR CALCULATING ONE AND THE SAME MASS FLOW.
PLEASE CHECK THE EQUATIONS WITH WHICH THE MASS FLOWS ARE
CALCULATED.

SPECIFYING ONE OF THE FOLLOWING WILL SUPPLY ONE EQUATION TO
CALCULATE A MASS FLOW IN ONE OF THE PIPES CONNECTED TO THE
APPARATUS OR GROUP OF APPARATUSES:
* PARAMETER EEQCOD 1 IN STEAD OF 2 (APPARATUS TYPES
"CONDENSER", "HEAT EXCHANGER", "NODE", "COMBUSTOR",
"REFORMER", "FUEL CELL", "MOISTURE SEPARATOR" AND
"GASIFIER")
* PARAMETER DELM FOR A MASS SOURCE OR SINK (A BEGIN OR AN END
OF AN OPEN SYSTEM, RESPECTIVELY)
* A PRODUCTION FUNCTION FOR AN APPARATUS OR A GROUP OF
APPARATUSES
* A SURPLUS POWER FOR A DRIVE TRAIN WITH ONE OR MORE TURBINES
AND ONE OR MORE PUMPS/COMPRESSORS
* PARAMETER LAMBDA FOR A "COMBUSTOR" (WITH EEQCOD=2)
* PARAMETER UOX FOR A "FUEL CELL"
* PARAMETER POWER FOR A "FUEL CELL"
* PARAMETER OFRATI FOR A "GASIFIER"
* PARAMETER SFRATI FOR A "REFORMER" OR A "GASIFIER"

PLEASE REFER TO THE MANUAL TO SEE THE EQUATIONS
THAT A CERTAIN APPARATUS TYPE WILL SUPPLY TO THE SYSTEM
MATRIX FOR CALCULATING THE MASS FLOWS IN THE SYSTEM.